To remove the ignition barrel from a Falcon, first, ensure the vehicle is off and the key is removed. Next, locate the small pin or release tab on the underside of the ignition switch, which often requires a flathead screwdriver to press in. Turn the key to the "on" position while pressing the pin, then pull the ignition barrel out. Finally, disconnect any wiring harnesses attached to the ignition switch.
The ignition barrel can be removed by removing the retaining ring. The barrel will slide out. Remove the wiring harness from the back of the barrel.
I would contact Falcon by email. Sales@falcon-airguns.co.uk and ask them.
to remove stilo ignition barrel, look underneath the barrel. there is a square button holding the barrel in. put the key in the ignition, turn 2 notches, and press the button in with a screwdriver. Then wiggle the barrel out using the key.
how to remove key barrel from a XR8 steering column
To remove the ignition barrel from a Citroën Xsara, first disconnect the vehicle's battery to ensure safety. Then, remove the steering column cover by unscrewing the necessary screws. Insert the key and turn it to the "on" position, which will allow you to press the release button on the ignition barrel. Finally, pull out the ignition barrel gently to remove it from the steering column.
Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.
To remove the ignition barrel on a Ford Transit, start by disconnecting the battery to ensure safety. Then, use a screwdriver to remove the steering column cover and locate the ignition switch. Insert the key and turn it to the "on" position while pressing the release tab on the ignition barrel to remove it from the steering column. Finally, pull the ignition barrel out gently and disconnect any wiring harnesses attached.
you have to remove lower plastic cover should be two screws this will give you access to barrel holder place the key in barrel and there is a small pin that you have to press in with a small pointy object I used straightened paper clip when you have pushed in the pin turn key to acc then pulling on the key barrel should remove hope this has been of help
Remove the ignition retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition.
To remove the ignition barrel on a Combo van, first disconnect the vehicle's battery to ensure safety. Then, you'll need to remove the steering column cover by unscrewing any screws and gently prying it apart. Insert the ignition key and turn it to the accessory position; locate the release tab or screw on the ignition barrel and press or unscrew it while pulling the barrel out. Once released, you can fully remove the ignition barrel from the steering column.
The barrel is not timed properly to the switch.
To remove the ignition barrel from a Daewoo Lanos, first ensure the steering wheel is unlocked by inserting the key and turning it. Next, disconnect the battery to prevent any electrical issues. Remove the trim around the ignition switch, then locate and remove the retaining screws or clips holding the ignition barrel in place. Finally, insert the key, turn it to the "on" position, and gently pull out the ignition barrel.