0
To remove the wiper arm from a 1987 Suzuki Samurai, first, lift the wiper arm away from the windshield to a vertical position. Locate the retaining nut at the base of the wiper arm and use a socket wrench to remove it. Once the nut is off, gently rock the wiper arm back and forth while pulling it straight up to detach it from the splined shaft. Be careful not to damage the windshield or the wiper shaft during the process.
What else can I help you with?
What is the length of a 1987 Suzuki samurai?
135"
What is the spark plug gap for a 1987 Suzuki Samurai?
1987 Suzuki Truck Samurai 1.3L 2BL SOHC 4cylThe Spark Plug Gap.032 (In thousandths of an inch)
Where can you find a 1987 Suzuki Samurai complete engine?
boneyard
How many rpms does a 1987 suzuki samurai have?
try a tach
Where is bonnet release for 1987 Suzuki Samurai?
In the glove compartment.
Where is the fuse panel on a 1987 Suzuki Samurai located?
The fuse panel on a 1987 Suzuki Samurai is located under the dashboard on the driver's side. It can be found to the left of the steering column, typically near the area where the steering wheel meets the dashboard. To access it, you may need to remove a cover or panel.
Where is rear brake adjuster on 1987 suzuki samurai?
Download the FREE Suzuki Samurai Shop Manual from http://www.suzukiinfo.com/ or visit zukikrawlers.com zn
Where can you buy a blower motor switch for an 1987 Suzuki Samurai?
Suzukijohn.com
What is the correct placement of the spark plug wires to the distributor on a 1987 Suzuki Samurai?
Download the FREE Suzuki Samurai Shop Manual from http://www.suzukiinfo.com/ or visit zukikrawlers.com zn
Where is the oil drain plug on a 1987 suzuki samurai?
it is the only one on the oil pan.
Does a 1987 suzuki samurai have fuel injection?
Yes. There is a fuel injected engine and a carbed engine.
How do you remove the front seats from a 1987 Suzuki Samurai?
To remove the front seats from a 1987 Suzuki Samurai, start by locating the seat adjustment lever and moving the seat forward for better access to the rear bolts. Use a socket wrench to remove the bolts securing the rear of the seat to the floor, and then slide the seat back to access and remove the front bolts. Once all bolts are removed, gently lift the seat out of the vehicle. Be sure to disconnect any wiring for seatbelts or electronic components if applicable.
