0
The answer is a simple one, although you would be best served by being a petite contortionist. :)
* The first step is to crawl under the dash and remove the antenna Lead wire to free the power antenna from the radio.
* Once that is accomplished you need to remove the retaining nuts that secure the antenna to the passenger side fender (set them aside since you might need them later).
*Now comes the "Petite Contortionist" issue (I bet you thought you had gotten past that when you had to crawl under the dash?). Turn your engine on and to either the extreme right (or left depending on whether you're right or left handed), then turn your engine off and remove the key. Now you get to contort your body into the rear side of the front passenger side wheel well (If you are big like me that could take some time and effort). You should now be able to identify the antenna lead cable. Unscrew the power box (at the base of the antenna) and gently pull the old antenna from the inside of the fender and the radio antenna lead cable from the passenger cabin side. Alright! You're 1/2 the way home!
*Now just reverse all the above steps (with your new antenna, of course!) and there you are... pulling in all those sweet FM stereo channels once again.
Good Luck!!
What else can I help you with?
How do you repair or relace the power antenna on a 1996 Toyota 4 Runner?
i dnt really no but i no i has somthing 2 do wit the car hahaha lols
How do you replace a power antenna on a 2002 Toyota 4-runner?
http://www.carstereohelp.com/stereoremovalToy4Runr2PwrAnt.htm
Does a 1994 Toyota Celica have a power antenna?
My 1994 Toyota Celica has a power antenna.
Does the 2010 4 runner have a power antenna?
Sorry no. The 2010 4Runner doesn's have a power antenna.
How do you repair power antenna on a 1991 Toyota Cressida?
To repair the power antenna on a 1991 Toyota Cressida, first, ensure the vehicle is off and disconnect the negative battery terminal. Remove the interior trim panel to access the antenna assembly, then carefully detach the antenna motor and wiring harness. Inspect the antenna for any visible damage or obstructions, clean or replace components as necessary, and reassemble everything in reverse order. Finally, reconnect the battery and test the antenna to ensure it operates correctly.
What else is on the Toyota 4-runner clock fuse?
It is interior fuse #18 ACC 15 amps it controls car audo, power antenna, clock, and power rear mirror
How do you repair Toyota matrix antenna?
To repair a Toyota Matrix antenna, first, inspect the antenna for any visible damage or wear. If it's a manual antenna, ensure the cable is intact and the mounting base is secure; you may need to replace the antenna mast if it's broken. For power antennas, check the motor and wiring for faults, and if necessary, replace the entire antenna assembly. Lastly, reassemble everything, ensuring all connections are secure, and test the radio reception.
How do you repair replace a 1987 Corvette power antenna?
Remove the wiring harness from the bottom of your 1987 Chevy Corvette power antenna. Remove the power antenna retaining nuts. Reverse the process to install your new power antenna.
Can you replace the power antenna on a 1995 Toyota Camry with a manually fixed rod antenna?
yes u can
What is running and how do you replace it when your 2000 Toyota 4 Runner has a grinding pump noise under the right front fender that runs for 10 seconds when you turn the start key on and off?
Could it be the power antenna?
Can you replace power antenna on 99 4 runner without replacing it with a power antenna?
There are a lot of aftermarket antenna masts that you can get to fit your 4 runner and if you do decide to go with a fixed mast just make sure that you make sure that the wiring harness at the mast doesn't ground out on any metal. Other than that there is no problem with replacing it with a fixed mast antenna.
How do you replace the antenna on a 1989 Toyota Camry LE Is it a power antenna?
To replace the antenna on a 1989 Toyota Camry LE, first, ensure the car is turned off and disconnect the battery. If it has a power antenna, you may need to remove the interior trim panel to access the antenna's motor and wiring. Unscrew the old antenna from the exterior, disconnect its wiring, then install the new antenna by reversing the steps. Finally, reconnect the battery and test the antenna to ensure it functions properly.
