What question
You will have to remove the door panel and replace the regulator assembly. In some cases it comes as an assembly with the motor.
You can get a window regulator for a 1993 Geo Tracker at auto part stores. You can also check with local salvage yards.
To replace the window on a 1993 Dodge Dakota, start by removing the door panel to access the inner workings. Carefully detach the old window by removing any screws or clips securing it in place, and disconnect the window regulator if necessary. Install the new window by aligning it with the regulator and securing it in place, then reassemble the door panel. Finally, test the window to ensure it operates smoothly.
Hi, I just had the LF window regulator replaced in my '93 Topaz. Had to get the regulator from an auto junkyard because the car is 17 yrs. old--cost me $40.00 for the all metal regulator and a local body shop friend did the work for about $50.00. Works like new--good luck
To replace the front driver's side window on a 1993 Ford Escort, first, remove the interior door panel by unscrewing any visible screws and gently prying off clips. Next, disconnect the window motor or regulator if necessary, and carefully remove the broken glass. Insert the new window into the regulator or track, ensuring it is aligned properly, then reattach the door panel and test the window for proper function. Make sure to clean up any glass shards before finishing the installation.
un plug the connector at the window regulator, check for 12V, if you have it when you press the switch up or down, its your regulator, if not it mat be the window switch or a problem further up a wiring diagram Justin
To install a passenger window on a 1993 GMC Sierra, first, remove the door panel by unscrewing the fasteners and carefully prying it off. Next, detach the old window by removing the window regulator and any clips or bolts that hold it in place. Insert the new window into the regulator and secure it according to the manufacturer's instructions. Finally, reattach the door panel and test the window to ensure it operates smoothly.
power window motor removal 93 sunbird
Remove the plastic head liner panel (roof)Take out the plastic side storage bins in the backseat (sides) Then the rear window plastic side plates can be removed. Factory 4x6's.
Disconnect the battery, Remove the door panel, vapor barrier plastic, power window connections, and I would remove the entire regulator assembly with motor attached. It helps to have someone hold the window as it drops inside of the door. Some motors are riveted to the regulator at the factory, so if it is I would obtain a good used assembly at a salvage yard. I have done these in a couple hours. Looks harder then it is.
How do i change the window on a 95 chevy astro van