0
What else can I help you with?
How to replace 2002 Pontiac Montana Battery?
To replace the 2002 Pontiac Montana battery disconnect both the battery cables from the terminals. Then, remove the screw to the battery holder, located behind the battery. Slide the battery slightly to the front of the vehicle and lift up. Reverse this procedure to put in a new battery.
How do you fix front seat warmers on 2002 Pontiac Montana?
2002 Montana Seat Repair
Where is the block heater cable on my 2001 Pontiac Montana?
The 2001 Pontiac Montana block heater cable can be found in the front of the vehicle. You can access the block heater cable through the front grill.
Where is the water pump located on a 2000 Pontiac Montana?
on the front of the engine
How do I replace the starter in 1999 Montana?
Begin by removing the positive cable from your battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new Pontiac Montana battery.
What is the right location for jack placement when jacking up a 2000 Pontiac Montana to replace the front tire?
When jacking up a 2000 Pontiac Montana to replace the front tire, the correct location for the jack is the reinforced jacking point located on the frame near the front wheels. This is typically just behind the front wheel well, where a small notch or mark may indicate the spot. Always ensure the vehicle is on a level surface, and use jack stands for added safety once it is lifted.
How do you replace front fender 98 Pontiac Bonneville?
How do you replace passenger side fender on a 1998 pontiac bonneville se
Where can you find instruction to replace the front wheel bearings in a 2002 Pontiac Montana?
Haynes Repair Manual. I had to replace front passenger side wheel bearing. The manual will walk you through it. I did have to get a pulley puller in order to get the brake disc off. Pretty straight forward though.
How do you remove oil pan on Pontiac Montana?
you must remove the front suspention crossmember and suspension.
2003 Pontiac Montana control arm bushing checking?
Check front end for play.
How do you replace front brake pads on a 1992 Pontiac Transport?
With a wrench.
How do you change front turn signal on 2006 Pontiac Montana?
You can change the front turn signal, on your 2006 Pontiac Montana, by removing the retaining nuts. Remove the wiring harness. The turn signal will come free. Reverse the process to install the new turn signal.
