0
To replace the front axles on a 2001 Pontiac Montana, start by safely lifting the vehicle and removing the front wheels. Next, detach the brake caliper and rotor, then remove the axle nut from the hub. You may need to disconnect the lower control arm to allow the axle to be extracted from the hub. Lastly, install the new axle by reversing the removal steps, ensuring everything is securely tightened before lowering the vehicle.
What else can I help you with?
How much to replace front axles?
of what?
How much to replace front axles on 2000 bravada?
how much to replace axles on a 2000 bravada
Replacement of drive shaft on 1996 voyger?
The front axles do not have a removable shaft, you must replace axles completly.
How do you replace the front axle and abs sensor on an 02 escape?
what do i have to do to replace the front drive axles on a 2004 ford ecscap???
How to replace 2002 Pontiac Montana Battery?
To replace the 2002 Pontiac Montana battery disconnect both the battery cables from the terminals. Then, remove the screw to the battery holder, located behind the battery. Slide the battery slightly to the front of the vehicle and lift up. Reverse this procedure to put in a new battery.
How do you fix front seat warmers on 2002 Pontiac Montana?
2002 Montana Seat Repair
Where is the block heater cable on my 2001 Pontiac Montana?
The 2001 Pontiac Montana block heater cable can be found in the front of the vehicle. You can access the block heater cable through the front grill.
Where is the water pump located on a 2000 Pontiac Montana?
on the front of the engine
How do I replace the starter in 1999 Montana?
Begin by removing the positive cable from your battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new Pontiac Montana battery.
What is the right location for jack placement when jacking up a 2000 Pontiac Montana to replace the front tire?
When jacking up a 2000 Pontiac Montana to replace the front tire, the correct location for the jack is the reinforced jacking point located on the frame near the front wheels. This is typically just behind the front wheel well, where a small notch or mark may indicate the spot. Always ensure the vehicle is on a level surface, and use jack stands for added safety once it is lifted.
How do you replace front fender 98 Pontiac Bonneville?
How do you replace passenger side fender on a 1998 pontiac bonneville se
Where can you find instruction to replace the front wheel bearings in a 2002 Pontiac Montana?
Haynes Repair Manual. I had to replace front passenger side wheel bearing. The manual will walk you through it. I did have to get a pulley puller in order to get the brake disc off. Pretty straight forward though.
