The front axles do not have a removable shaft, you must replace axles completly.
two
p/n 4565238
tail shaft
I am sure there are proper tools on the market, but I had to do "emergency replacement" in my driveway. I used a pry bar and a hammer for removal - worked okay.
First make drive shaft and yoke to insure tat they are replaced in the same location to maintain factory balance Remove small "U" bolts at yoke Pry drive shaft out of yoke Pull driveshaft off splined end
You will need to remove the drive shaft to tow a Jeep with a tow dolly.
If it is a 4-wheel drive then it is screewed into the transfur case, if it's not then it will be on the transmission tail shaft.
The universal joints in the front driveshaft may be going bad.
If it has shims now and you buy an OEM replacement starter, then use the shims. If it does not have shims then you will not need them. Replace the starter with an exactly duplicate, installed exactly as the original. If in doubt measure the distance from the mounting plate face to the end of the drive gear shaft and make sure that distance in the same on the replacement starter.
NS-Shaft was created in 1996.
NS-Shaft happened in 1996.
How do I remove a pully from the drive shaft. The snap ring that holds pully on has been taken off.Itried a gear puller but it bends the pully.