from inside, in footwell undo plate, headlight behind
For the 1994 model (B3000), you can't change just the bulb. You have to change the headlight assembly.
Resubmit question with make, model and year of the vehicle.
The valve clearance for the Mazda E2000 power van typically ranges from 0.15 to 0.20 mm (0.006 to 0.008 inches) for both intake and exhaust valves. However, it's essential to refer to the specific service manual for the exact specifications, as they may vary slightly based on the engine model and year. Regular checks and adjustments ensure optimal engine performance and longevity.
The valve clearance for a Mazda E2000 typically ranges from 0.20 to 0.25 mm (0.008 to 0.010 inches) for both intake and exhaust valves. However, it's always best to refer to the specific service manual for your vehicle, as specifications may vary slightly depending on the model year and engine configuration. Regular checking and adjustment of valve clearance can help maintain optimal engine performance.
Need to know the year, make and model.
The tappet (valve clearance) settings for a Mazda E2000 van typically vary depending on the engine type. For the 2.0L engine, the clearance is generally around 0.15 mm (0.006 inches) for both intake and exhaust valves when the engine is cold. It's important to consult the owner's manual or a repair guide for specific specifications and procedures, as settings may differ based on the model year and engine variant. Always ensure proper adjustments are made for optimal engine performance.
To set the timing on a 1990 Mazda E2000 van with an FE motor, first, ensure the engine is at top dead center (TDC) on the compression stroke for cylinder one. Then, locate the timing marks on the crankshaft pulley and the timing cover; align them according to the manufacturer's specifications. Adjust the distributor position if needed, ensuring the rotor points to the correct ignition wire. Finally, double-check the timing with a timing light to confirm proper settings.
You may receive an answer if you list the Make, Model, & Year. Without that information, I am afraid you will not receive an answer.
Not enough info. Please reask question with year, make, and model.
Depending on the model year, you probably have one low beam bulb and one high beam bulb in each headlight.... unlike 90-94 323s that had one 2-filament bulb in each headlight.
Yes it does I too own a Mazda protege 95 with a 1.5 liter and i had to replace the tone ring on my mazda. I ask what does this do and the shop told me its for the abs. But only the LX and ES model has it.
In a Mazda MPV, the headlight relays are typically located in the engine compartment fuse box. To access them, you may need to remove the cover of the fuse box, which is usually situated near the battery. It's advisable to consult the vehicle's owner manual for specific relay locations and diagrams, as they can vary by model year.