answersLogoWhite

0

You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you replace the license plate light bulb on a 2008 Cadillac STS?

if your under miles its under warrenty


How do you replace a cigarette lighter in a 2008 Pontiac Vibe?

To replace a cigarette lighter in a 2008 Pontiac Vibe simply refer to the user manual.


How do you change license plate bulbs for 2008 ford Taurus?

To change the license plate bulbs on a 2008 Ford Taurus, first, open the trunk and locate the license plate light assembly. Use a flathead screwdriver to gently pry off the light cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb by twisting it clockwise. Finally, replace the light cover and ensure it’s securely in place.


How do you change license plate bulbs on 2008 Hyundai santa fe?

To change the license plate bulbs on a 2008 Hyundai Santa Fe, first, open the rear hatch and locate the license plate light assembly. Use a flathead screwdriver to gently pry the light assembly out of its housing. Once removed, twist the old bulb counterclockwise to release it, then replace it with a new bulb by twisting it clockwise. Finally, reinsert the light assembly back into its housing and ensure it is securely in place.


How do you replace license plate light bulb on 2008 Honda Odyssey?

05+ Honda Odyssey license plate lights. Pop out the license plate lights in the rear. There are two of them. Use a very thin flathead screw driver and pop out the sides of the inner clear light assembly. They are on the sides. Once that is done, remove the light bulb and replace with a new bulb. Pop in the clear light assembly cover. Turn on lights to see if the bulb is working and it is is then you're done. Approximately 10-15 minutes total.


How do you change license plate bulb on a 2008 subaru legacy sedan?

The 2006 Legacy license plate bulb is accessed by removing the liner in the trunk and un screwing the plastic socket.


How do you remove front license plate bracket 2009 Mercury Mariner?

It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.


How do i test and replace my blend door actuater and control valve on 2008 pontiac g5 for my car that stopped blowing heat?

You can find detailed instructions on how to replace an door actuator and control valve on 2008 Pontiac g5 on youtube.com/watch?v=ttIZ_iCLFGo


Where is the battery on a 2008 Pontiac Torrent?

where the battrey located in a 2008 Pontiac torrent


Where is the block heater on a 2008 Ford Escape?

On my Escape XLT, you reach up under the front license plate. Ther cord is there with a nice cap on it. On my Escape XLT, you reach up under the front license plate. Ther cord is there with a nice cap on it.


How do you program a keyless remote for a 2008 Pontiac?

How to program a keyless entry remote for 2008 Pontiac g5


How do you program a keyless remote for a 2008 Pontiac G5?

How to program a keyless entry remote for 2008 pontiac g5