0
Not so easy.
This is pressed into the lower control arm.
So :
- Jack and support car
- Remove lower ball joint to upright nut.
- Separate ball joint from upright. Usually with a hammer and suspension fork.
- In some cases there is a spot weld that needs to be ground off in place of the snap ring.
- Remove the snap ring that retains the joint into the lower control arm.
- Use your portable ball joint and suspension press to remove and install the replacement joint.
- Assembly is reverse of disassembly.
What else can I help you with?
How do you change a ball joints on a 2001 Honda Civic?
Honda knows they have a problem with the passenger side lower ball joint on 2001-2005 Honda civic. refer to Honda service bulletin 04-079 dated December 21,2004. the bulletin describes how to remove the ball joint and Honda now has a ball joint replacement. however, the service bulletin suggests checking the opening in the knuckle to make sure it will receive the new ball joint. the bulletin also suggest that Honda will repair it even if it is out of warranty as a good will gesture. if not, purchase the entire knuckle assembly with a ball joint from majestic Honda. it will cost you about 100 dollars .
How do you replace cv joints in a 1993 Honda civic?
To replace the CV joints on a 1993 Honda Civic, first, safely lift the vehicle and remove the front wheels. Next, detach the axle nut, then remove the lower ball joint and any components obstructing the axle's removal. Slide out the old CV axle and replace it with a new one, ensuring the new axle is properly seated in the transmission. Finally, reassemble the components in reverse order, tightening all fasteners to the manufacturer's specifications.
What is the torque specification for the lower ball joint on a 2001 Honda accord dx?
The 2001 Honda Accord lower ball joint torque specification is 90 pounds. The lower ball joint should be torqued in 45 pound intervals.
Where is the Starter 1999 Honda Civic?
Look at lower rear of engine
How do you remove the radiator support in a 2000 Honda civic?
upper or lower?
Where is the OBD port on a 2001 Honda Civic?
The 2001 Honda Civic OBD 2 port is on lower right edge of dash; behind console trim
Do you need special tools to replace a 1997 Honda Civic right side CV joint and is it something you can do yourself?
You'll need a socket big enough to fit on the CV nut and you might need a fork for the lower ball joint. Both can probably be rented for an autoparts store that has tool rental program. It's free if you buy the part there.
2001 Honda Civic OBD Socket Location?
The 2001 Honda Civic OBD 2 port is on lower right edge of dash; behind console trim
How do i replace a Lower ball joint in 2001 Kia Rio?
You have to replace the lower control did assembly .
Where is the thermostat located on a 1996 Honda Civic?
at the top of the lower rad hose (in housing)
Where is the obd 2 plug for Honda 2001 civic ex?
Thee 2001 Honda Civic OBD 2 port is on lower right edge of dash; behind console trim
What is the size of the lower alternator mounting bolt on a 2005 Honda Civic?
You can find the size of the lower alternator mounting bolt on a 2005 Honda Civic on civicforums.com/forums/21-i-c-e-electrical/354635-diy-alternator-replacement.html
