You have to replace the parking brake handle assembly.
Bad switch on the emergency brake handle.
TAke off the left kick panel and there are bolts holding it on.
Easiest would be to disconnect the wire at the emergency brake handle.
the emergency brake pads ARE the REAR brake pads.
Buy a new one and you will see what all you have to take loose.
Usually located at the bottom of the emergency brake handle - may have to remove trim for access
The emergency brake must be on for the top to open. If the brake light on the dash does not come on with the emergency brake on then you will need to replace the switch on the emergency brake.
The emergency brake must be on for the top to open. If the brake light on the dash does not come on with the emergency brake on then you will need to replace the switch on the emergency brake.
That's what I am asking you. How do you replace a parking brake handle on an S-10 1996 Chevy Blazer?
There is no such thing as an "Emergency brake" in a vehicle. The PARKING BRAKE is the pedal to the far left against the edge of the driver's footwell. The handle above the pedal is the release.
Your brake light is probably brake fluid low or emergency brake on. Rear brake lights are replaced by removing the lens and replacing the dual filament bulb.