answersLogoWhite

0

you have to remove the steering wheel and the turn signal. this requires special tools that can be purchased or rented cheaply.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How can i replace an ignition switch in a 1989 Oldsmobile cutlas ciera sl?

Remove the retaining ring from the top of the ignition switch. Pull the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


How do you remove replace a 1989 Vanagon ignition switch?

Here is a link to an illustrated step-by-step procedure for replacting a Vanagon ignition switch: http://carboncow.net/vanagon/projects/ignition_switch.htm


How do you remove the ignition switch on a 1989 Chevy Corvette?

Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.


How do you change the ignition switch on a 1989 Chevy Blazer S10?

You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


How do you install ignition switch on 1989 Chevy G 10 van?

how do you install new ignition switch on 1989 chevy G10 van?


How can you start a 1989 mercury cougar with a broken ignition switch?

how can you start a '89 mercury cougar with a broken ignition switch?


How do you locate the ignition switch on a ford Bronco II 1989?

If you know where to put the key in, you know where the ignition switch is... Actually, safe to say you should stay away from it.


Is there a reset switch for the ignition on a 1989 Dodge colt gt turbo 1.6 liter?

No.


How do you remove and replace the ignition coil on a 1989 Toyota Celica?

you suck it up


Where is the flasher for a 1989 Chevy Cavalier?

It is located by the ignition switch on the right side of the steering column.


How do you remove the ignition switch on a 1989 Jeep?

To remove the ignition switch on a 1989 Jeep, first disconnect the battery to prevent any electrical shorts. Next, remove the steering column cover by unscrewing the screws that hold it in place. Then, locate the ignition switch, which is typically mounted on the steering column; detach the wiring harness and unscrew any mounting bolts to remove the switch. Finally, carefully pull the switch out from the column to complete the process.


Why won't a 1989 Jeep Cherokee keep running unless the key is kept turned to the start position?

you have a short or disconnected wire in the switch. you may need to replace your ignition switch. i have a 89 jeep and it was doin the same thing: it was the ignition module If one of the wires gets disconnected from the ballast resistor it will do the same thing.