To replace the thermostat on a 1992 Oldsmobile, first ensure the engine is cool, then disconnect the negative battery cable. Drain the coolant from the radiator, and remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, take out the old thermostat, and clean the mating surface before installing the new thermostat with a new gasket. Finally, reassemble the housing, reconnect the hose, refill the coolant, and reconnect the battery.
remove old thermostat and replace with new thermostat and gasket
Is there a picture of a Starter Solenoid for a Oldsmobile 1992
Where is the thermostat located and how do you replace it on 1992 toyota camry 4 cylinder ingine
First, remove the thermostat housing. Then grab the thermostat by hand and remove it.
The piston or spring on the thermostat could be stuck.
To replace a thermostat on a 1992 Geo Storm first locate the its housing. Once found drain the coolant system and remove the housing from the engine. Replace the thermostat.
On the 3.3L V6 it is under the radiator cap.
Replacing a thermostat on a 1999 Oldsmobile Cutlass is very easy to do. First you will find the thermostat by following the upper radiator hose. It is under the exhaust crossover. The thermostat has two 13 mm bolts holding it in place. Take the bolts off to remove the thermostat and replace with a new one.
To replace the thermostat on a 2000 Oldsmobile Silhouette, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator and remove the upper radiator hose connected to the thermostat housing. Unscrew the thermostat housing, take out the old thermostat, and clean the mating surfaces. Install the new thermostat, reattach the housing and hose, refill the coolant, and reconnect the battery.
this site is great
The thermostat is located where the hose leaves the engine to go to the top of the radiator. You unscrew the bolts holding the hose mounting to the engine. There you find the thermostat.
To replace the thermostat on a 2000 Oldsmobile Bravada, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then remove the upper radiator hose connected to the thermostat housing. Unscrew the thermostat housing, replace the old thermostat with a new one (ensuring the rubber gasket is in place), reassemble the housing, reconnect the hose, and refill the coolant before reconnecting the battery. Finally, start the engine and check for leaks.