To reset the airbag light on a Jeep Cherokee, first, ensure that the issue triggering the light has been resolved. Then, use an OBD-II scanner to clear the airbag codes. If you don’t have a scanner, you can disconnect the vehicle's battery for about 10-15 minutes to reset the system. Reconnect the battery, and the airbag light should turn off if the problem has been addressed.
No light on 95-96 cherokee. Thay are a self-contained unit.
The airbag light stays on when the computer has detected a malfunction and set a code. A scan tool is required to read the codes. The light can not be reset until the failure is repaired.
No
I have the same jeep and had the same problem its the clock spring thats broke you need to replace the steering colum or you can go and get the codes reset on it you can try to reset it your self disconnect your battery cables over night and it should reset your codes and your airbag light should go off mine did
The airbag light comes on at start up for a bulb check. It stays on when the computer detects a malfunction and sets a code.
The abs light is reset with a scan tool after repairing the failure that caused the code.
The airbag light stays on when the computer has detected a malfunction and set a code. The light can not be reset until the failure is repaired.
I Do not have jeep or one does not have an airbag
Where is the fuel reset button on a 2000 jeep Cherokee freedom
Unplug or replace maint. timer
There is no reset for the fuel pump on a Jeep.
It does not have a reset.It does not have a reset.