i have an acura cl 2001 what does the ! light on thr dashboard mean
There is no reset procedure for thesr lights , if there is a malfunction they will illumunate www.lextechautomotivellc.com
Turn key to position 2 and hold select and reset together for 10 secounds
you turn the key to on position hold the select and reset buttons for 10 seconds and it should go off
First you need to get the problem fixed that has caused the SRS warning light to come on. This is a repair for professionals. They will reset the light after the repair. Seek professional help.
You can reset the 2001 Buick Century low coolant warning light by removing the fuse. Keep the fuse out for 10 seconds, then replace it to its original spot.
To reset the SRS light on a 2001 Acura, first, ensure the ignition is off and disconnect the negative battery cable for at least 10 minutes. Then, reconnect the battery cable and turn the ignition to the "On" position without starting the engine. Press the SRS reset button, usually located under the driver's side dashboard, until the light turns off. If the light remains on, it may indicate a deeper issue that requires professional diagnosis.
I have a 2002 alero how do you reset, the coolant light is always on. Thanks, Alero owner
Push the select and reset switch at the same time, turn the ignition switch ON (II), and hold them more then 10 seconds. The above sentence came straight from the 2001 Acura TL service manual
To reset the SRS (Supplemental Restraint System) light on a 2001 Acura CL S Type, you typically need to use a diagnostic tool to clear any fault codes stored in the system. Alternatively, you can disconnect the car battery for about 10-15 minutes, then reconnect it, which may reset the light. However, it's essential to ensure there are no underlying issues with the airbag system before resetting the light. If the light persists, consult a professional mechanic for a thorough diagnosis.
The charging warning light should automatically reset if the battery is disconnected. Check the battery cables and ensure they are properly connected. Also check the alternator connections. If the light is still on there may be a problem with the new alternator.
To reset Maintenance light, switch key to on position, do not start. Press select and reset buttons at same time for about 15 to 20 seconds, then switch key off. If reset occured, the light will go off when you restart engine. If not, repeat process. Took three time for me.