To reset the brake wear indicator on a 2011 Renault Master, first, turn on the ignition without starting the engine. Then, press and hold the brake pedal while simultaneously pressing the gas pedal. After a few seconds, release both pedals. This should reset the brake wear indicator, and the warning light should turn off. If the light remains on, consider checking the brake system for any issues.
How can I reset engine light on renault master van 2012 125bhp
Renault Service - computer controlled indicator. You may change oil by yourself, but the indicator won't change until it is reset digitally. What does this mean?
Take it to Renault lol
Press the brake
The ABS indicator stands for the Automatic Brake System indicator. It can be reset by restarting the entire control display.
Read the relevant section in the handbook!
get a OBD2 (On Board Diagnostics) reader and reset the code.
replace front brake pads
see:- http://grumunkin.blogspot.com/2009/08/how-to-reset-service-indicator-on.html :-)
To reset the low brake pad indicator on 2010 Ford Trans IT simply turn on the ignition and press the foot brake and the accelerator simultaneously. The accelerator and the foot brake should be pressed at the same time.
To reset the service indicator, start the vehicle normally. Afterwards, press the button on the end of the dashboard, and hold it in. It will begin flashing through some options, but if it is held down through the flashes, it will reset the service indicator.
how to reset the brake service indicator on mini cooper s 2011