answersLogoWhite

0

Use a dwell meter if you can get your hands on one. Give us the year, make and engine info and we'll give you the point gap and dwell specs. Most point gaps ranged from .015" to .025". You can use a matchbook cover if you are in a jam. The thickness of a matchbook cover is just under .015".

User Avatar

Wiki User

9y ago

What else can I help you with?

Related Questions

What is the gap on a spark plug for a ford focus 1600 t reg?

It doesn't matter. DO NOT USE A FEELER GAUGE!!! Ask the parts store for plugs for your car and install them right out of the boxes. A feeler gauge will scratch the platinum and ruin them. They will not fire correctly and the car will lose power. It cost ME $150.00 to find this out the hard way.


How do i stop valve noise 2001 Lincoln town car?

adjust the valves- the clearance between the rocker arm and the valve should be checked with a feeler gauge.


How do you set the points on a Volkswagen beetle?

There are two ways. Both start the same way. The cheap and dirty method requires a .016" feeler gauge, a 30mm wrench and a flat-tip screwdriver. Take the distributor cap off, followed by the rotor. Turn the engine with the wrench until the points are open all the way. Stick the feeler gauge into the gap (pry them open if you have to). Loosen the hold-down screw a little, then tighten it again. If you can get the gauge out and back in again without prying the points open, put the car back together and you're done. The right way is to use a dwell meter. Hook it up, set it to the 4 Cylinder setting and start the engine. If the dwell is 50 degrees (plus-minus 2) you're done. If it's too low, the points are too far open. If it's too high, they're too far closed. Adjust as necessary to get it right.


What vehicles come with a digital car gauge?

Vehicles do not come with a digital car gauge. You have the option to install a gauge in your car at the time purchase.


Why does the temperature gauge on your car fluctuate?

The temperature gauge on a car fluctuates because the car's thermostat is opening and closing. The gauge goes up when the thermostat closes and the gauge goes down when the thermostat opens.


Why is there an arrow on a car's fuel gauge?

If you are referring to the little arrow under the gas symbol, the arrow points to the side of the car that the gas cap is on. Very useful if you drive a lot of different cars!


What is the gap for the ignition points on a 1965 mustang?

The gap for the ignition points on a 1965 Mustang is typically set to 0.017 inches. This gap is crucial for ensuring proper ignition timing and engine performance. Using a feeler gauge, carefully adjust the gap between the points to the specified measurement for optimal functioning of the ignition system.


What is the correct gauge wire for a car radio?

The correct GAUGE wire is 28 for a car stereo.


How much is it to fix a coolant leak and can you still drive your car?

There are innumerable points for the leak, cost for repair will depend on where it is. You can drive the car only if the leak is minor and the temperature gauge shows normal temperature.


Can the car overheat without the gauge showing hot?

Yes, a car can overheat without the gauge indicating hot. This can occur if the temperature sensor is malfunctioning or if there is a problem with the gauge itself, preventing accurate readings. Additionally, issues such as a coolant leak, blocked radiator, or failing water pump can lead to overheating even if the gauge does not reflect it. Therefore, it's important to monitor other signs of overheating, such as steam or unusual engine noises, and to perform regular maintenance.


Strain gauge in a car?

How I know if the strain gauge is gone


What is a good wire gauge for a car radio?

A good wire gauge for car radios is 18 gauge. This wire runs between the radio and its power supply from the vehicle.