answersLogoWhite

0

Install the crank gear so you can see the dot on it at all times,Then turn the grankshaft until the dot on it is at 12:00 oclock,stright up. Now leave the chain off and install the cam gear the same way with the dot out. After putting all 3 bolts in the gear finger tight turn the cam gear until the dot is stright down at 6:00 O'clock stright over top of the other dot. NOW it is in time. Remove the 3 bolts and gear and then install the timing chain and gear back on being sure that the dot is stright down. While doing this be SURE that neither gear moves / rotates. Tighten the 3 bolts up and then make sure that the 2 dots are stright over top of each other. 12:00 and 6:00

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you set timing chain and gears in Chevy 350 from scrach?

with no.1 cylinder at top dead center, line up the mark on the cam gear with the mark on the crank,and install the timing chain.


What should the timing be set at on a Chevy 350 with an edelbrock performer cam and manifold?

10-12 degrees


What happens when the crank sensor or cam position sensor goes out in a 1998 Chevy Malibu?

crank sensor will cause car to no start cam sensor will only set check engine light kbutlrtech@yahoo.com


How do you set the timing on a 350 Chevy engine with dual cam gear drive?

Put #1 piston up then take off the timing chain cover off and make sure that the time crank marking are lined up


How is the timing gear set in a 1995 350 z-28 camaro?

The mark on the cam gear should be at 6 o'clock and the mark on the crank gear should be at 12 o'clock.


What should the timing be set at after you have replaced the timing chain on a 1994 Chevy s10 2.2 liter engine?

Put the crank shaft at TDC. There is a dot on one of the crank gear teeth. It should be pointing toward the cam gear. Put the cam gear on without the chain. Turn the cam until the hole in the cam gear is pointing toward the crank. In other words, the hole in the cam gear and the dot on the crank gear should be in line. Then simply remove cam gear and apply the chain. The computer does the fine timing. Nothing to adjust.


Small Block Chevy 350 timing?

how do i set the timing for a chevy 350 small block?


How do you setthe timing on 350 Chevy?

how do you set the timing for a 1997 Chevy 350 5.7 engine


W to set the timing marks on a Chevy 305 cam and crank?

Crank gear dot should point stright up / 12o clock with #1 pistion at TDC.all the way up at the top of #1 cylinder.The cam gear dot should point stright down At 6o clock. That will make both dots stright over top of each other. Then the crank and cam will be in time.


What should the timing be set at for a Chevy 350 with a 284 degree duration camshaft?

You need to contact the cam manufacturer. Usually 32-40 BTDC @ 3000 rpm.


How do you set cam timing on a Yamaha big bear 350 4x4?

You set cam timing on a Yamaha big bear 350 4x4, by opening up the bike chassis and looking for the cam timing levers. You can adjust it up or down until you have it set to how you want it.


Where do you set the marks on the cam and the crank on a1990 2500 5.7?

assuming youre replacing the timing chain. the cam and crank sprocket marks are to point directly towards each other.