To remove number plate lights, first, locate the screws or clips securing the light assembly, usually found on the top or side. Use a screwdriver or appropriate tool to remove these fasteners, then gently pull the light assembly away from the vehicle. If the light is held in place by clips, carefully pry them open. Finally, disconnect the electrical connector to fully remove the light.
The number plate light is usually on the same circuit as the head lights.
the fuse should be labelled tail lights.(whats the problem with no. plate lights?)
The license plate lights are not in a separate fuce by it seft. They are the same as your side marker lights. So, check if your side marker lights are working and if they are them is a bad license plate light bulb.
Radio fuse
Undo the screws around the number plate, take the number plate off then put the new number plate on.
The owners manual indicates fuse # 12 in the Fascia fuses is for the number plate and a number of other things including Hazard lights.
try changing the bulb, you can get them from halfords
For a 2003 Vauxhall Vectra, the fuse for the number plate lights is typically located in the fuse box and is usually a 5A or 10A fuse. You can find the fuse box under the dashboard or in the engine compartment, depending on the specific model. It's advisable to consult the owner's manual for the exact fuse location and specifications. If the number plate lights are not functioning, checking this fuse is a good first step.
No it is not illegal, as long as you have operational tail lights, brake lights, signal lights and a plate light.
to wire the license plate lights you must have lights and wire them to the scooter.
No, the license plate light is wired in with the rear tail lights, not the brake lights.
The tail lights and plate lights are on the same fuse, if the tail light come on it is not the fuse. Plate lights are not checked that often and it is common for them both to be brunt out when they are noticed.