answersLogoWhite

0

If this Pontiac Tempest is the same car as a Chevy Corsica, and it has a v-6, it should be automaticly tightened. If it wont tighten, you might check to see if it has the right belt, If it is the right belt, it could be the automatic belt tensioner.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you loosen and or tighten the drive belt on a 1990 Ford Thunderbird?

You can't, the belt is called a serpentene belt, you have to replace the belt.


How do you tighten belt on 1990 Isuzu trooper?

To tighten the belt on a 1990 Isuzu Trooper, first locate the tensioner pulley. Use a wrench or ratchet to turn the tensioner arm, which will relieve tension on the belt. Once the belt is loose, inspect it for wear and proper alignment, then reposition or replace it as needed. Finally, release the tensioner to tighten the belt back into place, ensuring it is secure on all pulleys.


How do you change a timing belt for a 2.0 Liter 1990 Pontiac Lemans?

there is no 2.0l Pontiac lemans.it must be a swap from sunrunner.


How do you change the serpentine belt on a 2003 Pontiac Bonneville?

To change the serpentine belt on a 2003 Pontiac Bonneville, loosen the tensioner pulley and remove the old belt. The tensioner pulley is the wheel in the belt system that has a bolt through the middle in a slot that can be adjusted. Put the new belt on and tighten up the pulley.


How do you change the belt that runs the power steering pump on a 1990 Mazda B2200?

THERE IS A BELT TENSIONER BELOW AND JUST TO THE RIGHT OF THE FAN PULLEY. LOOSEN IT COMPLETELY, AND THE NEW BELT SHOULD FIT RIGHT ON. THEN TIGHTEN THE TENSIONER TO TIGHTEN THE BELT, AND YOUR DONE. GOOD LUCK, DANNY.


How do you tighten the drive belt on a 1987 Pontiac fiero?

You move the AC compressor and the alternator to adjust tension. Has to be done from under car.


How do you tighten fan belt on Mitsubishi L200?

how do you tighten fan belt on l200


How do you tighten the fan belt on a peugeot 205?

just in front of the altenator, there is a 10mm bolt, tighten that and it will tighten the fan belt


How do you install an AC belt in a 1990 Lincoln town car?

Go There is a nut behind the idler pulley. There is no spring like in most idler pulley's. You must loosen the nut first then use a 1/2 breaker bar or an belt tool to tighten the belt. Then re-tighten the nut.


How do you tighten a loose drive belt?

To tighten a loose drive belt, find the pully that is connected to the belt. Tighten the pully and then hold the belt in place using the adjuster belt. Check out the related video to see an example of how this is done.


How do you tighten belt on kawasaki brute force?

how do u tighten belt on brute force 750?


How do you tighten fan belt rover 214?

You can tighten a fan belt by tightening the tensioner pulley. Pry to the left on the tensioner pulley and tighten it.