answersLogoWhite

0

You can't, It's not adjustable what so ever. There is another problem somewhere if it's idleing to fast are to slow. The Idle speed is controlled by the ECM/ computor.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is an idler gear?

An idler gear is a gear which connects two other gears so they will turn in the same direction. :)


What would cause an idler pulley to freeze up on a 2000 Chevrolet 1500 express van?

There is a small bearing in there and sometimes they just fail. The bearing can't really be changed so you'll have to buy a new or used idler pulley.


What colour wire on tachometer 1992 Chevrolet pick up?

usually green


How do you crank up torsion bars on 1992 Chevrolet?

what kind of Chevy on 4 wheel drive pickups follow the bars back to the trans bolts will be facing down be sure to turn them evenly


How do you turn up the bass in a 1991 Chevrolet truck?

the bass button on radio


How do you replace the alternator water pump power steering belt on a 1992 Nissan Stanza?

Not sure if the 92 is the same as the 91, but on the 91 you need to loosen the adjusting idler on the alternator on top and the a/c idler from the bottom. remove the a/c belt & install the alt. belt, make sure your route is correct between the two guide as the belt goes up to the idler... hope that helps.


What would causes a 1992 Chevrolet vet to crank up runs then dies after a few seconds?

You are losing spark or fuel.


Examples of simple gear with idler?

Most rear wheel drive Pick up trucks with manual transmission have an idler to provide reverse.


How do set the clock on a 2004 Chevrolet Malibu classic?

turn off radio, hold up or down arrow until it beeps. down is for hour and up is for minute.


How do you change the right front turn signal lamp on a 1995 Chevrolet Camaro?

reach up under front bumper and twist the bulb out.


Where is the turn signal relay located on a 2001 Chevrolet Camaro?

I beileve its located under the driver side of the dash up by sterring colum


Do you need to know what the torque would be to find out if the idler tension pulley has to be torqued when you install the serpentine belt on a 1995 Oldsmobile Cutlass Supreme?

there is not a specific torque for the idler pully. tighten it up with a ratchet and it will not loosen up