0
What else can I help you with?
What does a knock sensor for a 1991 Chevrolet Camaro 305 look like?
the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.
How do you remove heads on a 305 Chevy?
To remove the heads on a 305 Chevy, first disconnect the battery, carb and throttle cables. Also disconnect the sensors and vacuum hoses. Unplug water temp gauge sensor on the thermostat and disconnect pump from brackets.
Where is the water temp sensor at in a 1986 Chevy 305?
driver side cylinder head between spark plugsdark green wire to itthis is for the guage or light, in dash
Will a coolant temp sensor on a 1989 camaro 305 cause it to run bad?
Yes. A bad or failing temp sensor prevents the ECM from monitoring, and adjusting for, the engine temperature.
WHY Hard start 305 hot or cold tbi?
Try replacing the engine coolant temp sensor.
How many wires are connected to the knock sensor in a 82 Chevy k10 305?
1 wire.
Where is Chevy trailblazer coolant temp sensor located?
where is the temperture sensor located on a 2002 chevy trailblazer with a 4200 motor
Where is the temperature sending unit on 86 Monte Carlo 305 HO?
Try looking on the side of the left head it should be a one wire sendor, ground that wire to the block if the temp gauge maxs out that means the temp gauge is good.
Where is Coolant temp sensor on a 1984 gm 305?
On the engine block between the first and second spark plugs on the drivers side of the engine.
Is there another coolant sensor that would affect the operation of the dashboard temperature gage on a 1991 Chevy K1500 305 the temp sensor next to the thermostat housing has already been replaced?
There is a sensor located between exhaust manifold #1 and #3 (drivers side). This sensor controls the temp gage in a cars interior.
When your 92 Chevy pickup wit a 305 fuel injected motor reaches normal temp it runs rough?
possibly a engine temp sensor. need more info, this is a good start.
How do you adjust the timing on 1995 Chevy with a 305 v8?
There is a brown wire below the glovebox this you unplug then you can turn your distributor after adj plug this wire back together! Engine should idle at 900 / 1100 rpm
