Look by valve cover. Be careful, some cars requre a special alignment tool for installing cam sensors. It is located on the backside (drivers side) of the engine at the end of the exaust cam. It requires a number 30 torx bit to remove it. 2 screws hold it in and no special alignment tools are needed to replace it.
That is what its supose to do, Computor is advanceing the timing
oxygen sensors. could be the culprit . There are too many things that it could be. Take your car to autozone and they will run a scanner. I bought one from them for about $30.
According to the 2010 Ford Ranger Owner Guide : With engine oil filter change : The 2.3 liter Dual Over Head Cam four cylinder engine takes ( 4.0 U.S. quarts of 5W-20 ) The 4.0 / Single Over Head Cam / V6 engine takes ( 5.0 quarts of 5W-30 )
Harley-Davidson Oil Pressure Specs for the Twin Cam Engine: Cold engine start-up: 44-50 psi. Warm engine at 2000 rpm and up: 30-38 psi. Warm engine at idle: at least 10 psi.
According to the 1999 Ford Taurus Owner Guide : With engine oil filter change : The 3.0 " Duratec " Dual Over Head Cam , V6 engine takes : ( 5.2 litres of 5W-30 engine oil )
Sandra Cam was born on June 30, 1972.
Sandra Cam was born on June 30, 1972.
Cam Burke was born on 1987-04-30.
The 2000 Lexus RX 300 is equipped with several sensors that contribute to its various systems, including engine management, safety features, and comfort. Key sensors include the oxygen sensors, mass air flow sensor, and various temperature sensors, among others. While the exact number can vary based on specific configurations, it typically has around 20 to 30 sensors in total. For precise specifications, it's best to consult the vehicle's service manual or a Lexus dealership.
According to the 1999 Mercury Mountaineer owner Guide ( 5W-30 ) With engine oil filter change , both the 4.0 litre Single Over Head Cam , V6 engine and the 5.0 litre V8 engine take ( 4.7 litres / 5.0 U.S. quarts of 5W-30 engine oil )
Cam Ward is number 30 on the Carolina Hurricanes.