0
What else can I help you with?
Should the cylinder ridge be removed before the piston?
No, you dont need to remove the cylinder ridge before. I never have and i replace them all the time.
How to remove Clutch slave cylinder S10?
the slave clutch cylinder is located inside the housing of the clutch/transmission. Unless you really know what you are doing a trained tech probably should replace this part.
Where is the EGR valve located on a 2000 Hyundai Sonata 4 cylinder?
It should be on the intake or exhaust manifold.
How much should it cost to replace or repair replace valves a cylinder head on a 1998 grand am gt 4 cylinder?
about 1500 dollars
Can you flat tow a Hyundai Accent?
No you should not do it. Always replace it before moving the vehicle
How do you replace brake master cylinder on 2000 dodge neon?
Remove electrical connections from old master cylinder remove and plug brake lines remove mounting bolts and pull off from brake booster BENCH BLEED new master cylinder prior to installing Install in reverse order of removal If bench bled properly should not have to bleed brake lines
How do you replace the thermostat on a 4 cylinder 1996 ford ranger?
follow the top radiator hose to locate the thermostat housing, remove the hose from the housing then unbolt the housing. remove and replace the thermostat and rebolt the housing to the motor, replace the hose The housing is made of cheap metal and should be replaced. It is important to "seat" the thermostat properly. Also, it is much easier to replace and remove the thermostat housing if you first remove the timing belt housing.
How do you replace the timing belt on a 1992 Mitsubishi eclipse 4 cylinder dohc manual?
Remove the timing belt cover. There should be a pully that will ratched in and out to tighten and loosen the belt.
How do you change camshaft position sensor 2007 f150?
Remove ignition transformer to reach it. There should be 2 camshaft position sensors on the 5.4L engine - visibly on the front right cylinder head and the other visibly on the front of the left cylinder head. Remove ,Replace, then return ignition transformer.
How can repair the oxygen sensor for Hyundai Elantra 91?
replace it..It should screw right in with a wrench.
How do you replace the ignition lock cylinder on your 1993 Ford Festiva?
remove the two screws holding face plate in center of steering wheel and remove plate. next remove large nut in center. Using a steering wheel puller remove steering wheel. next there is a pin next tothe lock cylinder. that will have to be driven inwith a hammer and a punch. lock cylinder should be able to be pulled out. installation is the reverse of removal.
Should you replace your clutch master cylinder when replacing clutch?
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
