0
The cost to fix a brake line cylinder typically ranges from $150 to $300, depending on the vehicle make and model, labor rates, and whether other components need replacement. If the brake line itself needs repair or replacement, that could add an additional $100 to $200. It's advisable to get a detailed estimate from a trusted mechanic for a more accurate figure.
What else can I help you with?
Clogged brake line repair?
To fix a clogged brake line, first find the clog. Then, remove the clogged line from the cylinder. Attach a new line, and pump the car's brake to test it before driving.
How much will it cost to fix a back brake line on a ford tempo?
your virginity
How much to fix rear driver's side brake line on a 1994 GMC Sierra 4x4?
To fix a rear driver's side brake line on a 1994 GMC Sierra 4x4 at a shop can run as high as $300. The parts can be purchased to repair the brake line for under $50.
How do you fix a leak in the brake line in a 2001 Kia Optima?
it depends if it is a metal line or rubber lines , if it is at a fitting or at the master cylinder or abs i can help you find these if you cant locate the leak
How do you fix a broken brake line in a 1999 GMC Sierra?
Replace the brake line, bleed the brake. top up with brake fluid. Done.
How do you fix a pin hole in brake line on 1994 Lincoln mark viii?
You have to change the line, too much pressure to do anything else.
How do you fix wheel cylinder leaking brake fluid?
Rebuild the cylinders on that caliper.
How can you fix a brake fluid leak when it's a leak in the brake line?
depends where the leak is. In the brake line or at the pump? electric or mech brakes? if its in the line you should be able to replace the line section
How do i fix a 1976 mg midget master brake cylinder?
Begin by removing the brake lines. Remove the master cylinder retaining bolts. The master cylinder will come off. Reverse the process to install a new master cylinder.
What does it mean that nothing is coming out of the brake bleeder valve of a 1999 sunfire?
If nothing is coming out of the brake bleeder valve on a 1999 Sunfire, it typically indicates that there is a blockage in the brake line or that the brake master cylinder is not functioning properly. This could be due to air trapped in the system, a defective master cylinder, or a clogged brake line. It's essential to check for air leaks, inspect the brake fluid level, and ensure that the brake lines are clear to restore proper brake function. If issues persist, consulting a mechanic is advisable to diagnose and fix the problem.
Can you fix the mistake of putting engine oil in the brake fluid?
Yes. You can fix the mistake of putting engine oil in the brake fluid. It is the easiest if you just caught it as soon as you did it. In that case you disconnect the master cylinder as quick as possible from the brake lines. You do not want oil to clog the brake lines. Then you remove as much brake fluid, oil mix from the master cylinder as possible. Then you take a rag and clean out the master cylinder. Then you run brake fluid through the master cylinder until it comes clean. Then you run brake fluid through the brake lines to make sure they are clean. If brake fluid does not go through the brake lines, you did not catch it in time. You need to replace your brake lines and slave cylinders. You have just learned an expensive lesson.
How do you fix a brake master cylinder leak Nissan?
For your own safety replace, do not repair
