answersLogoWhite

0

If you are talking about removing the freon in the a/c system then you will need a freon reclaimer.............

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why would a car surge only when the air conditioner is on?

Maybe a 4 cylinder and just reacting to the additional engine power draw of the air conditioner compressor noticable as compressor cycles on and off


How much electricity does an average bathroom fan use compared to a dehumidifier?

A dehumidifier is pretty much the same device as an air conditioner. It has a compressor which uses freon to create a cold surface for water to condense on. The fan only is a simple fan that moves air. The fan is the smallest electrical draw as opposed to the dehumidifier. The fan can have a current draw of as little as 1/10 of an amp when the dehumidifier can have a current draw as much as 15 amps when the compressor is running.


Can you power 100volt compressor with 400watt inverter?

It depends on the draw of the compressor.


How would you replace the AC compressor on a 1997 Trans AM WS6?

If you do not have the recovery equipment and vacuum pump to draw the system down after installing the new compressor. You might want to leave the job to a shop that has the equipment. If you do it improperly it will void the compressor warranty and you will be buying a second compressor.


How do you fill freon and oil on empty compressor for 2001 kia spectra?

To fill the freon and oil in an empty compressor for a 2001 Kia Spectra, first, ensure the system is evacuated and properly sealed. Connect the refrigerant canister to the low-pressure service port and turn on the AC to allow the compressor to draw in the refrigerant. For oil, you can add the specified amount of PAG oil through the service port using an oil injector or directly into the compressor before installation. Always refer to the vehicle’s service manual for the correct quantities and types of refrigerant and oil.


How do you draw freon?

I use a lime green crayon. If you need to get it out of your AC, you will need a freon reclamation machine that can bleed it out safely.


How you check amp draw on compressor?

Divide the power rating (in watts) by the voltage (in volts). So if you use a 100 watt light bulb in a typical 110 volt lamp then it will draw 100/110 = .91 amps of current. Or plug a 1500 watt electric heater into a 110 volt wall socket and it will draw 1500/110 = 13.6 amps of current.


Should you shake the freon when charging your ac?

You should just let the system take the refrigerant out of the can by itself. It is not good to force liquid r134a into the low pressure side of the ac. The suction of the compressor will draw the r134 out by itself and stabilize the system as it goes, it may just take longer than you want.


How many amps does a dewalt compressor draw?

The amp draw of a DeWalt compressor can vary depending on the model and specifications. However, most DeWalt compressors for residential use typically draw between 10-15 amps. It's important to check the specific model's manual or specifications for accurate information.


How can you test a compressor to see if it has shorted?

You would need to put an amp-meter on the circuit to see what the current draw is like. ====== If the compressor is shorted to ground you cannot check the amp draw because it will constantly kill the circuit breaker. A better way to go would be to check the continuity of the compressor to ground and each winding.


Can a 2000 watt run a camper air conditioner?

Not really. A 2000W generator will give you about 10 amps. Your normal RV air conditioner will draw 12-15.


Can you put down a Draw 4 card on top of a Draw 2 card in the game?

No, you cannot put down a Draw 4 card on top of a Draw 2 card in the game.