answersLogoWhite

0

Look under the front bumper and you will see 2 wide hole for access. Inside, at the 6'oclock positon is a 10mm screw, just twist counter clockwise, and pop the foglight out. I got a replacement pair on eBay for about 90 bucks. Pop those back in, put screw back in, plug in. Done.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you replace fog light lens on a Toyota Highlander?

Trying to replace the fog lamp lens on a toyota highlander 2005, Having trouble figuring out how to remove the defective ones.


Where is the fog light button on a 2004 ford explorer?

pull the headlamp control towards you to turn your fog lamps on


What bulb does the tiburon take?

I have a 2004 gt v6. The low and high beams are H7's. the Fog lamps are different i think they are 9006 I have a 2004 gt v6. The low and high beams are H7's. the Fog lamps are different i think they are 9006


How do you replace fog lamps on a 1999 Cadillac Catera?

look under the vehicke where the fog lamps are and you will see a rubber housing that fits around the openin gof the fog lamps, Now take off the rubber seal and you will see the mini bulb and alls you have to do is push forward on both of the small springs and it will release and from there you can tak eoff the mini fog lamp bulb.


How do you replace a fog light bulb on a Jeep Liberty?

There is a small square "trap door" in each wheel well directly behind the fog lamps. You can pry it open and access the fog lamps. They just twist loose. Untrue...in the 2008 Liberty in any case.


Why do fog lamps show up more in fog than other lamps?

Fog lamps on a car show up a lot more in the fog than other lamps simple because they are much brighter. It is therefore advised that you only use them in extreme cases of fog as it can cause issues for other drivers if you have your fog lights on when there is little to no fog.


If you replace the Fog Lamp of your 2004 VW Passat with after market lamps do you need to do any rewiring or is it plug and play so to speak?

If there are already lamps there you can as you say plug and play. I suggest when you expose the wires you seal with a genorous amount of electrical tape or a shrink tube.


How do you replace a fog light assembly on a '05 highlander?

To replace the fog light assembly on a 2005 Highlander, start by removing the screws or clips securing the fog light cover under the front bumper. Once the cover is off, disconnect the wiring harness from the old fog light and unscrew the assembly from its mounting bracket. Install the new fog light by securing it in place, reconnecting the wiring harness, and replacing the cover. Finally, test the new fog light to ensure it works properly.


Where is the turn on switch for the fog lamps on a 2004 Jeep Wrangler Rubicon?

turn on the running lights and pull out on the multi switch.


How do you change the fog lamps in a 2009 Chevy aveo LT?

To change the fog lamps in a 2009 Chevy Aveo LT, start by accessing the fog lamp housing, which is located behind the front bumper. You may need to remove the underbody shield or wheel well liner for better access. Once you reach the fog lamp, twist the socket counterclockwise to remove it, then pull out the old bulb and replace it with a new one. Reassemble the parts and test the fog lamps to ensure they are working correctly.


How do you replace fog light bulb in 2004 Acura TL?

Fog light bulbs are found underneath the headlights on a 2004 Acura TL. Follow the wires that flow into the lights and undo them from the housings. Pull them off and replace them.


How do you turn on the fog lamps on a 1997 Town and country?

On my 2000 town and country, you pull out the headlight switch, fog lamps only work on low beam On my 2000 town and country, you pull out the headlight switch, fog lamps only work on low beam On my 2000 town and country, you pull out the headlight switch, fog lamps only work on low beam