0
What else can I help you with?
Does a thermostat need rtv silicone if it has a rubber ring already?
If a new rubber ring is used and the surfaces are clean and free of nicks there is no need for additional sealer.
How do you replace the rear window on a 1994 Chevy Silverado?
To replace the rear window in a 1994 Chevy Silverado you must first remove the old window. This can be done by removing the seal around the window and gently pulling the window out. Apply rubber sealer around the new window opening in the truck. Wrap a rope around the rubber sealer of the new window and position it in the window opening. Carefully remove the rope once the window is resting properly in position. As the rope is removed the rubber sealer should hold the window in position. Reapply the rubber seal if it is available for extra security. Allow the window to set for 10 minutes.
Are caskets air tight?
Only those caskets are air (and water) tight which are "sealer" caskets, meaning that they are provided with a rubber like sealing gasket between the lid and the base of the caskets. Usually only metal caskets can be sealer caskets.
Concrete Sealer?
form_title= Concrete Sealer form_header= Seal all the projects in your home with concrete sealer. What is the sealer for?*= _ [50] How much sealer do you need?*= _ [50] Have you ever used sealer?*= () Yes () No
When changing transmission filt do you need to use gasket sealer on gasket?
replace corke with new and install dry if it is the rubber reusable just wipe off and reinstall
What is the part of can sealer?
"can sealer" is a noun phrase composed of "can" an adjective and "sealer" the noun itself.
Why does your vacuum sealer not seal bags?
I had that problem and it was the foam rubber seals in the top and bottom were worn out.Try taking them out and turn over and if that doesn't work you might have to get new ones.
How do you install a windshield on a 1994 Toyota 4X4?
I never changed the windshield on this vehicle, but I have done it with several other vehicles. Remove the old windshield and moldings that might be there. Remove as much of the old gasket sealer or glue (whatever you want to call it). VERY IMPORTANT....Before you install the windshield roll a couple windows down some. If not the first door closed will blow the windshield out of the sealer and it will forever leak. Next put a good amount bead of the glue around the window frame of the car. Just dont put so much on that it drips onto the dash. Then (with two people) place the windshield on the glue. I like to put some weight spred across the windshield to keep it pressed in. Not too much though you dont want to break it. That is it really just leave it be for a while. I usually wait five or six hours. Whatever the drying time says. Then replace any moldings and the rear veiw mirror. Good luck.
What is the best sealer for decoupage projects?
The best sealer for decoupage projects is a water-based polyurethane sealer.
What is the meaning of can sealer?
Can sealer is device or a machine that can seal a can for easy storage or alike. In home can sealer usually used it in resealing the food for later use. In some huge industry that can sealer or case sealer for there product packaging.
Is one coat of primer sealer enough to go ahead and paint over stock paint on 91 Chevy?
I would use at least 3 coats of primer sealer. It's not very dense and will waste the whole job if not done properly.
Why is your trunk leaking?
the bolts inside of trunk holding plastic bumper have rubber washers that go bad from over tightening and they will leak there. fixed my Seville with gasket sealer and new washers.
