0
What else can I help you with?
What are the torque setting of the main bearing caps and rod bearing caps on a Chevy 350 4 bolt main block?
inner main caps 70 ft. lbs, outer main caps 65 ft. connecting rod torques are 45 ft. lbs (caps)
How do you tell if 350 has a four bolt main?
Pull the oil pan off and count the bolts in the main caps, 2 bolt main engines only have 2 bolts holding the main caps to the engine block. 4 bolt main engines have 4 bolts holding the main caps on.MAIN CAPS IS WHAT HOLDS THE CRANKSHAFT IN THE ENGINE BLOCK.
Are toilet caps necessary?
If your talking about the caps that cover the floor flange bolts, NO they are not necessary for the toilet to function there are for aesthetics
How do you get the back seat out of a '93 Nissan Maxima?
You have to remove the 2 bolts from the floor and 2 from high on each side of the seat backs. The tricky part is then you have to put the armrest down and look for 2 small plastic caps covering bolts that are sometimes tough to get out. Then the seat should come out.
What tool do you need to remove caps over wheel bolts?
a wrench
Identify 350 four bolt?
Remove the oil pan and count the bolts on the main caps. The 2 end ones will only have 2 bolts each in them no matter what. If it's a 4- bolt main, then all the middle caps will have 4 bolts per cap.
How do you remove the console in a 96 A4 Audi?
you have to loose the bolts in the console ,for do that ,got like little caps ,the size for the caps is 8.mm should have for 4 bolts ,after that pull the console to the back and to up, in that it. i hope this help you
What is the torq spec of a 1996 350 crankshaft bearing caps?
If it's a 4 bolt Then the outer bolts for #2, 3 and 4 caps are 70 ft lbs all others bolts are 80 ft. lbs If its a 2 bolt main engine the torque spec's are 80 FT. lbs For all caps.
Where is 1 on the distributor cap of 91 Nissan 240 and plugs 1-4 on the engine?
printed on most caps
Who many bolts in a 350 Chevy?
Are you referring to the main caps? If you are some had two bolt mains, and some had four bolt mains.
What is the torque settings for 1400 Nissan bakkie?
The torque settings for a 1400 Nissan bakkie, specifically for the cylinder head bolts, are typically around 70 Nm (Newton-meters) for the initial torque and should be followed by a further angle-tightening procedure, usually around 90 degrees. For other components, such as the main bearing caps and connecting rod bolts, the torque settings may vary, so it's essential to consult the vehicle's service manual for specific details. Always ensure to use a calibrated torque wrench for accurate settings.
What are the bottom end torque settings for a 1.5TD vauxhall corsa?
Main bearing caps==Oil the bolts and tighten to 88Nm. Con rod caps (big end)Use new bolts,torque to 25Nm + 100 degrees + 15 degrees. Flywheel bolts 30Nm + 45 to 60 degrees. Need angle guage for two previous items,or can mark out a card disc. Oil baffle to cylinder block 26Nm. Oil intake pipe to block(new O-ring)19Nm. Sump bolts 10Nm.
