0
What cause the RPM go down and goes up when you turn the stirring wheel on neon 2000?
turning the steering wheel uses pressure from the Power Steering pump and puts a load on the engine causing it to slow the rpm. Should rise again when you stop turning the wheel. completely normal.
What else can I help you with?
What is the cause of a loud whining noise when a 2000 Buick LeSabre speeds up but stops when it slows down?
Bad wheel bearing.
Does stirring soup help to cool it down?
Yes, stirring soup helps to cool it down by distributing the heat more evenly throughout the soup, allowing it to cool faster.
Will full synthetic oil on 2000 1500 ram 5.9 cause oil pressure go up and down?
No, it will not cause that.
Where are the fuses on a 2000 VW cabrio?
You need to get down low underneath your steering wheel and there you will see a fuse panel cover.
What would make a 2000 gmc clunk when wheel is turnedor a whining noise when driving down the road?
It sounds like a wheel bearing has gone. DO NOT continue to drive until you have had it checked out.
What will cause a humming noise while car is going down the road I think right front?
Possibly the wheel bearing.
What would cause your car to cut off while turning the steering wheel?
A bad alternator. Turning the steering wheel all the way is very demanding on the power steering which draws power from the engine and can cause the idle to dip down. A weak alternator is usually the cause for the stalling.
A 1993 Mercury Villager has a loose steering wheel it moves up-down and side to side. What would be the cause of this?
Bad bearing?
What would cause your 1995 Silverados brake pedal to be so hard to push down?
sounds like a frozen wheel cylinder to me.
What would cause a bad vibration and grinding sound on the left front wheel side of the truck while going down the road at speeds above 20 mph?
Brakes, wheel bearing.
Where is the starter located in a 2000 Dodge Intrepid 3.2 liter?
The starter on a 2000 Dodge Intrepid 3.2 L is located on the driver's side of the motor. It is way down low next the fly wheel area.
What would cause Grinding in wheel while driving?
Your brakes are dragging, likely the pads are worn down to the steel. Hope this is helpful, www.TunerTools.com
