answersLogoWhite

0

a loose connection will do that if local near connector

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What is wrong with your 1997 s10 if the blower motor will not work?

If you have no blower speeds at all check the fuse, then check the blower motor switch and electrical plug for a melt down situation, then check the blower motor itself.


Blower motor in your car turns on and off by itself?

Heater motor switch and or the connection at the switch is melted. Also check connections at the blower motor and blower motor resistor for melt down damage.


Why does the ac resistor overheat and melt?

Excessive curent draw, usally a weak blower motor.


What caused glaciers to begin to melt?

Global


When was The Heat Can Melt Your Brain created?

The Heat Can Melt Your Brain was created on 2004-09-14.


How do people cope with the problems caused by ice?

they melt it !


Why would wire harness to blower motor resistor melt down?

The blower motor is going bad and drawing too much current.The blower motor is going bad and drawing too much current.


When did the boscastle flood start?

The Boscastle flood started in 2004 by torrential rain and the river Jordan burst its banks. It was also caused by snow melting, due from the winter. The rain helped the snow melt and the river to burst, therefore, caused a flood


No blower for AC or Heat 96 Escort Wagon. Fuse is good with Power at the Fuse box?

Blower motor located at the passenger side under the dash. Probably the blower motor but you need to check the blower motor resistor and the plug to the resistor. A common cause is the plug tends to melt & short out.


2001 Pontiac grand prixfan works on high only for acheater bloweri have already changed resistor for blower and still only works on high?

Blower switch and connection had a melt down.


Why does the blower motor switch and harness melt on an E series Ford van?

see nhtsa action no ea1003 about this problem.


Is it dangerous to run a gas furnace without the blower motor working?

Yes, you can melt the heat exchanger and start a fire that way