balls. balls will slow shafting
You Are Putting To Much Load On Your Engine. When It Starts To Stall Drop It Into Regular Drive. Also You Need To Drive At Slow Speeds In Regular Drive. At Speeds Say Around 50 MPH You Can Use OD. By Allowing Your Car To Slug Around In Overdrive You Are Doing Your Transmission In Amoung Other Things. Your Car Was Not Designed To Run This Way. Stay Out Of Overdrive At Slow Speeds. This Should Solve Your Problem. If This Does`nt Have A Good Tune UP.
I'd try changing tires, worked for me.
yes its caused by the air flowing to slow over the wing or if the angle of attack is to high and this causes turbulence
Binding in the linkage, bad windshield washer motor
The first thing I would try would be cleaning the throttle body with some carb and choke cleaner. When they get really dirty it can cause you to stall at slow speeds. On my 93 there is a Crank Shaft Position sensor. Mine started to melt and the jeep stalled at weired times for a week. If your jeep has a lock up solenoid in your tranny and its stuck on, then you will stall at stops Not sure about a 94, but my 2000 would stall while driving at highway speeds. Dealer replaced the oxygen sensor and it fixed the problem.
Idle slows down to a stall when you stop or slow down when AC is running. How do I adjust idle or is something else wrong?
Yes, a bad capacitor causes blower motor to become slow or stop. Since bad or shortcapacitor will make the surge of current and tripping of circuit breaker.
Have you checked to see if the elect. fan comes on ?
A delta
Weak battery or alternator output.
Very slow or fast transmission speeds become from what combinations of hardware and software?