1st make sure your using an obd1 code reader it may have an obd2 style port but its not its obd 1 then you need to check the wiring if thats good then it needs a pcm
Go on line and type in; abs code for 1993 camaro and click on on of the sites. It tells different codes for the different problems other people had with there camaro.
You need the "number codes" for the car.Look on any Camaro/Firebird website.3rd gen .org is good one.
There's over 100 Chevy codes that will make it come on-you need to have code read
To reset the check engine light on a 1996 Chevy Camaro Z28, you can use an OBD-II scanner to clear the diagnostic trouble codes (DTCs). Alternatively, you can disconnect the negative battery terminal for about 15 minutes, which will reset the vehicle's computer and turn off the light. However, ensure that any underlying issues are addressed before resetting the light to avoid further complications. After reconnecting the battery or using the scanner, the light should turn off if no active issues remain.
my 92 camaro is fitted with the anti theft device i changed the ignition switch and the car will not start need codes what are they??
To reset the computer on a 1990 Chevy Beretta, disconnect the negative battery terminal and leave it disconnected for about 15 minutes. This will clear any stored error codes and reset the engine control unit (ECU). Afterward, reconnect the battery terminal, and the computer will be reset. It’s also a good idea to check for any trouble codes if the check engine light was on before the reset.
intake manifold vaccum leak
A lean bank can be caused by bad sensors or wiring. Run computer test codes for any other problems, then follow the service manual for possible causes of the bad codes.
The check engine light comes on at start up for a bulb check. If it stays on with the engine running the computer has detected a malfunction. You need to have it checked for codes.
2000 chevy impala sterio wireing color codes
Removing the positive battery terminal for 5 minutes will clear the codes and reset the computer. But, the light will come back on in short order if the problem that caused the light to come on in the first place is not corrected.
To reset the computer on a 2002 Chevy Prism, you can disconnect the negative terminal of the battery and leave it disconnected for about 15 minutes. This allows the vehicle's computer to reset. After reconnecting the terminal, start the car and let it idle for a few minutes to allow the computer to recalibrate. Alternatively, you can use an OBD-II scanner to clear any error codes directly.