0
What else can I help you with?
How do you replace an alternator belt for a 1993 Infiniti Q45?
You must loosen the nut on the tensioner pully the from under the car there is a tensioning bolt 12mm you will tighten it and it will pull the pully down then take the belt off, new one on, then loosen the tensioner bolt til the belts tight and tighten the bolt in the middle of the pully then your all done
Is there a special tool for the tension on a2005 dodge 3.3 serpentine belt?
the idler pully makes the tension. to remove belt you use a wrench push tensioner in a direction that would loosen the belt as if you were trying to tighten or loosen the bolt holding the pulley on. carefull high tension.
What direction do you turn the crankshaft pully bolt to remove it from a 2002 Honda S2000?
counter clockwise.
Which direction does the crankshaft pully bolt turn on oldsmobil intrigue?
Lefty=loosey, righty=tighty.
What direction does a pully tentionure turn to come off?
i have a 00 mustang with a 4.6l gt. i need to pull off the pully tentionere. but i dont know what direction the bolt should be turn to losen it up. does any one know what direction.
Which direction do you loosen a Honda civic crank pulley bolt?
Counterclockwise. Skweekah
What direction do you turn the 21mm center bolt when taking off the crank pully on a 1997 kia sportage?
counterclockwise.
What direction does the crankshaft pully bolt come out in a 1998 Honda accord vtec 4 cylinder?
It Turns Counterclockwise
How do you lessen the tension on the serpentine belt on a 1998 Grand Cherokee 4.0L six cylinder with air?
This belt is tightened by a manual system. The key is to loosen the bolt located on the tensioner pully, then loosen the adjustment bolt located above and to the left of the pully. For the 4.0L, there is an adjustment bolt behind and on the engine side of the power steering pump. It runs diagonally behind the pump and the tension pulley. In order to loosen the tension, the bolt on the tension pulley must be loosened first. This pulley is the one below the power steering pump. Tighten the pulley bolt again once the adjustment has been made.
How do you loosen the serpentine belt on a 1992 Dakota V6 3.9L?
thier should be a tensioner pully with a 5/8 bolt on it on the front of the motor if not i don't know
What direction do you turn the oil pan bolt on a 98 Jeep Cherokee?
Counter clockwise to loosen.
How do you remove a 2005 Nissan altima auto tensioner pully?
The 2005 Nissan Altima auto tensioner pulley can be removed by removing the center bolt. You will need to hold the pulley stationary while you loosen the bolt.
