answersLogoWhite

0

a stall will not engage trans until a minimum rpm is reach depending on rpm range of the stall converter

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Can you put a th350 torque converter in a th400?

yes as long as it is not the 350C lock up convertor and have or need the right stall for your needs.


Why did your Engine stall while driving also rotten egg smell 1999 daewoo leganza?

sounds like a bad catalytic convertor


What would cause a 82 F150 engine to stall when put in gear automatic trans?

It could be that the torque convertor is locked and not slipping which it should do as the normal operation


Why would the car lose power and stall while I am driving?

I suspect you have a clogged fuel filter. If you are smelling something that smells like rotten eggs, it is your catilytic convertor.


Why would a 1992 Ford F-150 stall when put in reverse?

could possibly be the torque convertor. wiil it go if you give it some gas going from neutral to reverse or does it still stall ? check shift linkage for pinching a wire when shifted , good luck !


Can you convert mp4 to mp3?

Yes you can if you download a convertor like divx convertor.


Is there any freeware that can convert your video to different formats?

any video convertor is the best video convertor, u can also try ojosoft total video convertor or even imtoo video convertor also.........mahesh


Why would a car start but stall when put into gear unless it sits a while?

Hey Bob==You don't say what kind of car it is but if it is a GM it can be the torque convertor needing a new solonoid. GoodluckJoe it is a 1990 420sel mercdes benz


Why would a 1995 Pontiac Sunfire stall when coming to a stop from highway driving but not on regular street driving restarts fine?

there is a part on the transmission called the torque convertor solenoid ..intown driving your car is not moving very fast,out of town or freeway driving your creating alot of heat ,the torque convertor solenoid is going out ,soon it will stall intown also as it gets worse.you can have it replaced or you can unplug it and your car will run fine ..the purpose of the solenoid is to downshift your automatic transmission when coming to a stop ..you can try this to be sure it is this part..shift car to neutral as you come to stop if car does not stall then that's your problem.if it does then it is most likely something in your throttle body ,idle control solenoid etc.,


Where is oxygen sensor 2 bank 1 located on a cavalier?

After the catalytic convertor. Sensor one is before the convertor.


Where on a 98 van Pontiac transport is the oxygen sensor?

There are 2. One in front of catalytic convertor and one behind the catalytic convertor.


How do you change file type?

Use an online convertor. Most are free just type free online convertor into a search engine