The airbag light stays on when the computer has detected a malfunction and set a code. You need to have the system checked for codes to know possible causes.
The airbag light stays on when there is a malfunction. The failure needs repaired before the light will go out. You need to have the system checked for codes with a scan tool.
The airbag light stays on when there is a malfunction. The airbag computer will have stored a trouble code. When the failure is repaired the light will shut itself off.
The airbag light comes on at start up for a bulb check. It stays on when the computer detects a malfunction and sets a code.
The light will reset itself when the malfunction detected by the computer is repaired. You need to have the system checked for codes.
It stays on when the computer detects a malfunction and sets a code.
if the problem is fixed, then whoever fixed it should have reset it. if it isn't fixed, fix it.
It stays on when the computer detects a malfunction and sets a code.
I just had a warranty repair for an airbag indicator light malfunction on my 2005 Chrysler Town and Country. The service persons said it may be possible the airbag would not function properly in an accident if not corrected. They diagnosed the problem to be in a seatbelt sensor that is tied into the airbag system. The ordered part was installed on 9/19/08 and everything appears to be okay now.
I Do not have jeep or one does not have an airbag
The airbag light stays on when the computer has detected a malfunction and set a code. The failure will need to be repaired before the light will shut off.
The 'squib' is the wires that run between the computer and the airbag.
The passenger seat is wired for sensitivity to weight; anything on the seat will activate the light if it's not heavy enough, like a person; this includes ANYTHING that is in the seating area that may be pushing up against the back of the seat. rstubbins@mail.com