vdc off means your vehicle dynamics control is disabled
Try holding the "VDC off" button down for 10 seconds. Not sure, but worth a try. I think I might reset when you start up again.
Push the VDC button to turn it off. Look below the radio for the button.
I have a subaru outback 2001 LL BEAN and I don't know if mine has VDC or where to find the button to turn it on. ***** The VDC(Vehicle Dynamics Control) System works in conjunction with the ABS and the TCS(Traction Control System). It will automatically come on when you hit hazardous road conditions or if you make a sudden move, and will automatically go off when things are back to normal. So "you" don't turn it on, and "you" don't turn it off.....
To turn off the Vehicle Dynamic Control (VDC) in a Nissan G35, locate the VDC switch, which is typically found on the dashboard near the center console or on the steering wheel. Press the VDC button; an indicator light should illuminate on the dashboard, signaling that VDC is disabled. Keep in mind that disabling VDC can reduce traction and stability, so it should be used cautiously. Always refer to your vehicle's owner manual for specific instructions.
Lower left hand side below gauges, switch says VDC Off. That will turn it off.
To reset the VDC (Vehicle Dynamic Control) warning light on your Infiniti G35, first ensure that the vehicle is on a flat surface and the ignition is turned to the "ON" position without starting the engine. Then, press and hold the VDC off switch located on the left side of the steering wheel until the warning light turns off. If the light remains on, it may indicate an underlying issue that needs to be addressed. Always refer to the owner's manual for specific instructions related to your model year.
Go to thenewx.org and ask there. They are the the most knowledgeable people for 2nd gen xterras.
shut off the vdc
This will have to be done at the dealer.
VDC stands for the Vehicle Development Corporation who are based in Victoria, Australia. Their main area of business is converting cars and trucks from left hand to right hand drive.
Running, voltage should be around 13.5 VDC. It may be a little more but shouldn't be much less. Off, the voltage should initially be slightly over 12 VDC but will settle down to around 12 VDC after it sits for a while.
You need brake fluid