If your 1993 Fiesta jerks when changing gears at high revs, it could be due to several factors, including worn or damaged engine mounts that fail to stabilize the engine during gear shifts. Other potential causes include a failing clutch, transmission issues, or problems with the throttle response. It’s advisable to check for any signs of wear on the engine mounts and inspect the clutch and transmission for any faults. A thorough diagnosis by a mechanic would provide more clarity on the issue.
It depends on the exact model to which you are referring. Earlier models had three engine mounts; later models used four. If you are not comfortable or familiar with changing engine mounts, your best bet is to see an authorized mechanic, who can do the work needed.
check your engine mounts..I am not sure where they are but if you can move the engine with a prybar you need new mounts..they arent to expensive
Most likely the gearbox mounts are failing and need replacing. This can cause this problem even when the engine mounts are fine.
Cylinder misfire. Possibly failed or failing engine mounts.
A 1994 Corolla engine may vibrate if the motor mounts need to be replaced. The motor mounts can be purchased at any auto parts store.
The 1995 Dodge Neon engine mounts are located on each corner of the engine. There will be to engine mounts in the front and two engine mounts in the rear.
using a block of wood to protect the oil pan, lift the engine with a jack to take the load off the mounts while changing them
A little movement is normal but more than that may indicate broken motor mounts.
it has 4 mounts , 2 engine mounts, and 2 transmission mount
how many engine mounts are there on a 1991 corolla.
how do i change the rear top mount shock rubbers on a 1999 ford fiesta
Common causes of engine klunking noise in a car include issues with the engine mounts, worn out suspension components, loose or damaged exhaust system parts, and problems with the transmission or drivetrain.