0
What else can I help you with?
What is 2003 Chrysler pt cruiser spark plug wires firing order?
What is the firing order of a 2003 or cruiser
How do you tune up a Chrysler PT Cruiser?
Tuning up a Chrysler PT Cruiser can be done at home or by a mechanic. A tune up will consist of an oil change, changing the spark plugs and wires, air filter, and distributor cap.
What is a po353 engine code on a2001 Chrysler townand country?
there is a problem with your ignition coil or wires
What can cause the turn signals not to work on a 1993 Chrysler LeBaron?
Fuse, flasher, switch, bulbs, wires, ignition not on, dead battery,Fuse, flasher, switch, bulbs, wires, ignition not on, dead battery,
What are the colors and location of wires on the 1995 Chrysler LHS ignition wiring diagram?
In the 1995 Chrysler LHS ignition wiring diagram, the primary wire colors are typically as follows: the ignition coil wires are usually red and black, while the ignition switch wires may be red and brown. The ignition module often has a yellow wire and a green wire. For precise identification, it's always best to consult the specific wiring diagram for the vehicle, as variations may exist.
What type of ignition wires do you recommend for a 1993 Cadillac Seville with the Northstar motor?
The best ignition wires for the Northstar are the factory recommended AC/Delco OEM replacements. Anything else and you're asking for trouble.
How do you replace ignition wires on 1998 cirrus?
To replace the ignition wires on a 1998 Chrysler Cirrus, first, ensure the engine is cool and disconnect the negative battery terminal. Remove the old ignition wires by gently pulling them off the spark plugs and ignition coil, noting their order for reinstallation. Install the new ignition wires by connecting them firmly to each spark plug and the ignition coil, ensuring they are in the correct order. Finally, reconnect the negative battery terminal and start the engine to check for proper operation.
How shut off light fuel filter maintenance on a toyota land cruiser 2011?
Turn ignition on disconnect wires on top of fuel filter housing, leave for 10 seconds, replug together wires, turn off ignition.light should now be reset
How do you change ignition wires?
Are you referring to spark plug wires
How can i Change a dual pickup distributor to a points distributor on a 318 Chrysler motor?
To change a dual pickup distributor to a points distributor on a Chrysler 318 motor, first, remove the existing dual pickup distributor by disconnecting the ignition wires and the mounting bolt. Next, install the points distributor in the same position, ensuring it aligns properly with the camshaft. Connect the ignition wires according to the firing order and set the ignition timing as required. Finally, adjust the points for the correct gap and ensure everything is secured before starting the engine.
Who makes motorcraft ignition wires?
There are various companies who are known for making motor craft ignition wires. For example, there is a company called Motorcraft.
What colors are the ignition wires for 1972 Chevelle?
Just the plain black wires.
