0
What else can I help you with?
What is the torque settings for cylinder head and cam shafts of an Opel Astra 2000 model. Cde. 1.8 16v?
For the Opel Astra 2000 model with the 1.8 16V engine, the torque settings for the cylinder head bolts are typically around 25 Nm (18 lb-ft) initially, followed by a further torque angle of 90 degrees. For the camshaft bearing caps, the torque setting is generally around 10 Nm (7 lb-ft). Always refer to the specific service manual for your vehicle for the most accurate and detailed specifications.
What is the head torque on a 2001 Hyundai elantra?
10mm bolts torque to 18 Ft-lbs 12mm bolts torque to 22 Ft-lbs
What are the Daewoo Lanos camshaft torque specs?
Per the Haynes Repair manual for the Isuzu rodeo 2.2 engine which I understand to be the same. Here are the following torgue specs. Camshaft Bearing Cap Bolts 71 inch-lbs Camshaft Sprocket bolts step 1 36 step 2 60 degrees step 3 15 degrees Cylinder head bolts: 4 steps step 1 18 step 2 90 degrees step 3 90 degrees step 4 90 degrees Valuve cover bolts 83 inch lbs Please note inch pounds is used in a couple of these and that they require an inch pound torque wrench.
Torque for 2001 Ford Escape oil pan bolts?
For the oil pan bolts on a 2001 Ford Escape, the torque should be 18 ft lbs. This is equal to 24.4 N.m.
Torque specs for a dodge 4.7 exhaust manifold bolts?
18 ft lbs
Torque specs for 97 Pontiac grand am 3.1 rocker bolts?
18 ft pounds
At what torque must the Intake Manifold Bolts be tightened to on a Honda passport 97?
18 ft lbs
What torque should you use for Astra oil drain plugs?
Information is Limited on the Saturn Astra but after looking at the data on other Saturn engines. It would be a Safe to sayTORQUESOil Drain Plug.....18 ft-lbsHope This Helps.
Deawoo leganza head bolt torque specs?
Per the Haynes Repair manual for the Isuzu rodeo 2.2 engine which I understand to be the same. Here are the following torgue specs. Camshaft Bearing Cap Bolts 71 inch-lbs Camshaft Sprocket bolts step 1 36 step 2 60 degrees step 3 15 degrees Cylinder head bolts: 4 steps step 1 18 step 2 90 degrees step 3 90 degrees step 4 90 degrees Valuve cover bolts 83 inch lbs Please note inch pounds is used in a couple of these and that they require an inch pound torque wrench.
What is the torque specs for the brake caliper mounting bolts on a 2000 mercury villager?
18-25 ft lbs.
What is the torque specification on a water pump for a 1998 buick skylark wth a 3.1 liter engine?
According to the chilton manual the 5 water pump bolts torque to 89 inch pounds. The four bolts that hold the water pump pulley torque to 18 foot pounds.
What are the torque specs for the head bolts of a 1991 Mazda p220 4-cylinder?
the head bolts are tightenend to spec in 2-3 steps and go from 18-37
