0
What else can I help you with?
Where are the timing marks on a 1973 Chevy Nova?
The timing marks are on a tab adjacent to the harmonic balancer.
What is the firing order for a 1973 Chevy 350 with HEI ignition?
1.8.4.3.6.5.7.2
What are the ignition point gap settings for a 1973 Chevy 350 engine?
a 1973 Chevy truck has HEI Answer And if it does have points, say not the original engine, its .018-.019 will do.
What is the correct timing for a 1973 Chevy 350?
8 degress before TDC
What is the timing on a chavy caprice 1973 400 small block?
6 degrees advanced, or BTDC.
What is the timing for 1973 Chevy 350 bored 060 over?
10 degrees with a stock cam
How do you reset timing on 1973 454 Chevy after replacing distributor cap?
No need to if the distributor was not moved.
What is the timing for a 1973 small block 350 with a 4 barrel?
8*btdc manual 12*btdc auto
What is the ignition timing for a 1973 AMC 360 engine?
The ignition timing for a 1973 AMC 360 engine is typically set at 4 to 8 degrees before top dead center (BTDC) at idle, with the engine running at approximately 600-800 RPM. However, it's important to consult the specific service manual for your vehicle, as timing may vary based on factors like emissions equipment and any modifications made to the engine. Additionally, ensure to check the timing with a timing light for accurate adjustments.
What is the ignition timing point gap and spark plug gap for a 1973 Pontiac 455 v8?
the gap on the distributor points is .016, the timing is advanced 4 degrees and the spark plug gap is .030
How do you replace ignition switch in 1973 Chevy Nova?
To replace the ignition switch in a 1973 Chevy Nova, start by disconnecting the battery to ensure safety. Remove the steering column covers and locate the ignition switch, which is typically mounted on the steering column. Disconnect the wiring harness from the old switch and unbolt it from its mounting position. Install the new ignition switch by securing it in place, reconnecting the wiring harness, and reassembling the steering column covers before reconnecting the battery.
Will the crankshaft and heads from a 1973 Chevy fit a 1990 block?
Chevy in 1977 changed the rear main oil seal to a one piece seal. the older crankshaft wont work.
