The mounting location on an ignition coil typically refers to the area where the coil is secured within the engine compartment, often on or near the engine block or cylinder head. This location is crucial for proper functioning, as it ensures the coil is close to the spark plugs it serves. The coil is usually mounted using bolts or brackets to minimize vibration and maintain a solid connection. Proper installation is essential for optimal performance and longevity of the ignition system.
The plate that coil packs are placed on is typically called a "coil pack mounting plate" or simply a "coil pack plate." It provides a secure mounting location for the coil packs on the engine.
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
To replace the ignition coil: Unplug the wires from the coil, take note of how they come out so you can put them back. Unbolt the bracket from the intake manifold. The original coil is riveted to the mounting bracket, the new coil usually comes without the mounting bracket. Next cut the rivets off that hold the old coil to the mounting bracket. The new coil normally comes with bolts to hold it to the old bracket. Install the new coil to the mounting bracket then mount the bracket to the intake manifold. Plug the wires back in.
To change the ignition coil on a Volvo 740, first, ensure the engine is off and disconnect the negative battery cable. Remove the ignition coil's electrical connector and unscrew the mounting bolts securing the coil to the engine. Replace the old coil with a new one, reattach the mounting bolts, and reconnect the electrical connector. Finally, reconnect the battery and start the engine to ensure proper operation.
each spark plug has its own ignition coil on top of the plug, like many current cars.
The Ignition Control Module (ICM) is located directly above the coil. If you remove the 2 bolts holding the coil on and then romove the coil mounting plate from the car you will see a small rectangular module with wires plugged into it. This is the ICM.
the coil is mounted to a bracket with rivets. the bracket is mounted with 2 bolts. unbolt the bracket and drill or grind the rivets out . the new coil comes with mounting screws.
Disconnect your negative battery cable. Pull out the coil to distributer cap wire. unplug the wires going into the coil, remove the bolts holding the coil mounting bracket and slide coil out.
To install an ignition coil on a 1986 Chevy Celebrity: 1. With the ignition off unplug the wire harness from the coil, also remove the coil to distributor wire. 2. Remove the bolts that hold the coil mounting bracket to the intake manifold. 3, The coil should now come off. 4. The new coil comes without the mounting bracket. Therefore you must cut the rivets loose that hold the old coil to the bracket. The new coil should come with screws and nuts to mount it to the old bracket. Mount the coil to the bracket. 5. Position the coil mount onto the intake manifold and bolt it down. 6. Plug the cables and distributor lead back into place.
follow the center wire out of the distributor cap
Each spark plug has its own coil located on the top of each plug
They told me that i needed to replace the ignition coil on my 2004 Suzuki Verona, my question is how do i know which to change because i just found out the are 6 of them. Do i have to replace them all?