answersLogoWhite

0

The oil height on the crank for a 1972 Chevrolet 350 engine is typically around 5 to 6 quarts, depending on the specific configuration and whether it has an oil filter or other accessories. It's important to check the dipstick for the correct oil level, as the height can vary based on modifications and the type of oil pan used. Always refer to the manufacturer's specifications for precise measurements.

User Avatar

AnswerBot

4d ago

What else can I help you with?

Related Questions

What is the engine oil capacity for 350 ci chev engine?

Normally 5 quarts with a filter change on a stock 350.


Will a stp s5 oil filter fit a chev 350 engine?

Yea it does! Also fits 1998 chev 5.0 litre enginec


Where is oil sending unit on 1996 chev 350?

It's at the top rear of engine, near the Distributor.


Where is the oil pressure sending unit on a 1992 chev 350?

Top rear of engine, close to the distributor.


Where is oil sensor on 350 Chevy?

The Original small block Chev 262, 283, 302, 305, 307, 350 and 400 all had the oil pressure sender under the distributor at the rear of the engine between the two valve covers.


Where is the Oil drain plug and oil filter on a 2006 chev trailblazer fwd please be specific?

Where is the Oil drain plug and oil filter on a 2006 chev trailblazer


Will the head gasket be blown on a chev 350 if its run with no oil pressure?

No, the head gasket will be fine. BUT, it will probably score the cylinder walls, break the piston rings, score the crankshaft and seize the engine to run it with no oil pressure.


Does oil go in crank?

Yes oil does go on a crank and yes on it not in it!!


How do you change crank case oil 91 polaris 350 trail boss?

There is a large bolt on the bottom of the crankcase, underneath the brake.....that is your drain plug.


What causes low oil pressure in 94 Chevy silverado once it is warm 350 motor?

Typical of worn bearings....crank, cam and rod bearings.


Would anyone know On a 1993 chev pu 350 5.7 liter where is the oil pressure sensor?

It does not have a oil pressure senser. That's way you can't find it. But it does have a oil sending unit back by the distributor, underneith it but to the right. It will be screewed into the back of the block, up on top.


Can you rebuild a1995-2000 Chevy 350 engine block into a stock 1978 Chevy 350?

the new block has a two piece rear main seal and the oil dipstick is on the passenger side other than that yes reuse the crank and oil pan and everything else is interchangeable