0
What else can I help you with?
Where is the Plymouth Voyager oil pressure switch?
In a 1991 3.3l the oil pressure switch is located beside the oil filter
What chould the oil prusser br on a 1991 Isuzu trooper v6 be?
The oil pressure for a 1991 Isuzu Trooper with a V6 engine typically ranges between 10 to 50 psi (pounds per square inch) when the engine is at normal operating temperature. At idle, the oil pressure might be on the lower end of that range, while higher RPMs should show pressure closer to the upper limit. It's essential to consult the vehicle's service manual for specific specifications and ensure proper oil levels and viscosity are maintained.
Your 1991 ford ranger oil pressure gauge doesnt work what could be wrong?
Bad oil pressure sending unit?
What should the oil pressure be on a 1991 subaru 1.8 ltr engine?
The 1991 Subaru 1.8 liter engine, should have an oil pressure of 40 pounds per square inch. The oil pressure can vary five pounds, either way, and still be safe.
What are the 1989 cavalier Z24 specifications?
what specifications? oil pressure? horse power theres alot u need to be alot more spific
Oil pressure sending unit on 1991 ford ranger 2.3?
the oil pressure sending unit is designed to warn you of a low oil pressure. If the sensor goes bad then the low pressure light or gauge will read low when the oil pressure is actually ok.
What is low oil pressure?
Oil Pressure Sender and SwitchFord Ranger/Explorer/Mountaineer 1991-1999http://www.autozone.com/servlet/UiBr...3d800d46de.jsp
Where is the oil pressure senor is located Cavalier 1991?
The oil pressure sensor is located behind the engine just to the right of the coil packs
Which oil pressure control spring and piston and oil pressure relief spring and piston go where on a 1972 vw 1600?
In a 1972 VW 1600 engine, the oil pressure control spring and piston are located in the oil pump, specifically in the oil pressure relief valve bore. The oil pressure relief spring and piston are also part of the oil pump assembly, with the relief spring positioned above the relief piston. Make sure to install the correct spring and piston configuration according to the specifications for your engine to ensure proper oil pressure regulation. Always refer to the service manual for detailed guidance on installation and specifications.
What is the fuel-oil mix ratio on a 1991 Honda CR250R?
The factory owners manual recommends 20:1 fuel to oil ratio.
What would cause the oil pressure gauge on your 1991 S15 jimmy not to work and how do you fix it?
Have you change the oil pressure sending unit, that's what I had to do. David
What is the location of the oil pressure sensor in a 1991 s10 blazer?
it is under the distributor.
