answersLogoWhite

0

What else can I help you with?

Related Questions

What is a simple gear with idler?

An "idler" is typically used for tensioning of a belt, as in the timing belt, or a chain.


What is idler circuit?

current flowing at frequencies other than the input or output frequencies


Where is a simple gear with idler used?

Roller Shutter Doors


Examples of simple gear with idler?

Most rear wheel drive Pick up trucks with manual transmission have an idler to provide reverse.


What are examples of simple gear with idler?

Any type of trans in neutral


Example of a simple gear with idler?

all i know is it can be used in a transmission goodbye


How do you replace the AC belt on a 1995 Dodge Intrepid 3.5 liter?

On my 97 3.5L you have to loosen the bolt (15mm)on the front of the idler (loosen, don't remove) then go underneath and the is a 13mm bolt that adjusts the position of the idler for tension. Loosen this and the idler should loosen up.


How is the Simple Gear Train with Idler used?

A simple gear train with idler is a gear train the contains 3 gears. These gears are called the driver, idler, and driven or follower. The idler merely changes the direction of the follower so that it is the same as the driver.


What is comparative degree of idle?

idler


What is an idler on a Honda?

Most technicians refer to the idler pully for the timing belt as just idler.


Idler pulley diagram for a 2000 freightliner?

Need to know if you have a Detroit, Cat, or Cummins engine in order to answer this. As for the idler pulley itself, it's pretty simple to locate - it's the pulley which only spins, and doesn't actuate a pump, alternator, compressor, etc. Removing it is as simple as loosening the belt, unbolting it, and installing it in the opposite order.


What is the pulley under the alternator in a 1994 Chevy caprice 5.7L and how hard is it to change?

Are you talking about the "idler pulley"? They are quite simple to change. Loosen the serpentine belt by using a socket on the center of the tensioner pulley, slide the belt off the idler pulley, use a socket to pull the center bolt of the idler pulley and replace the pulley with a new one.