7.6 L
To change the thermostat on a Subaru EJ20 engine, first, ensure the engine is cool and disconnect the negative battery terminal. Drain the coolant from the radiator and remove the upper radiator hose from the thermostat housing. Unbolt the thermostat housing, replace the old thermostat with a new one (ensuring the gasket is in place), and reassemble the housing and hoses. Finally, refill the coolant, start the engine, and check for leaks.
Behind the radiator on the drivers side of a R/H drive car, Just above the engine undertray
on an ej20 and ej22 subaru engines the starter is located at the top of the engine and is held by a bolt at the top and a nut at the bottom once you have removed these the starter will slide out back towards the firewall
Since you didn't tell us the year or the model.2002 SUBARU IMPREZA 2.0L 4-cyl Engine Code EJ20 TurboCAPACITIESEngine, without filter..........4.8 quarts [1]Wix Oil Filter....513651. Add extra oil when replacing filter. After refill check oil level.Don't know if this is a Twin Turbo or Not.Hope This Helps.
it is in the water manifold
The torque specifications for the Subaru EJ20 engine vary depending on the specific component being tightened. Generally, for the main bearing caps, the torque is around 60 ft-lbs (81 Nm), while head bolts typically require around 90 ft-lbs (122 Nm) with a specific tightening sequence. It's important to refer to the specific service manual for the model year and configuration for precise values and procedures. Always use a torque wrench to ensure accurate measurements.
Neither is a chain, it is simple sprocket linked to the main shaft, will last longer that the car itself
most engines hold about 5 quarts
Engine bay, above the battery. Fuel lines running in and out. Can't miss it
i put a ej20 turbo out of a 02 wrx in mine and it worked out great for me make sure you swap the tranny as well its much stronger than the tranny in a 95 impreza l unless yours is only fwd then you will have to use your tranny
Just under the alternator.... check the link.... http://www.rb5ownersclub.co.uk/images/step3_i.jpg
The engine will only fit in right hand steered cars because of turbo issues with the brake master cylinder.