0
The torque specifications for the Subaru EJ20 engine vary depending on the specific component being tightened. Generally, for the main bearing caps, the torque is around 60 ft-lbs (81 Nm), while head bolts typically require around 90 ft-lbs (122 Nm) with a specific tightening sequence. It's important to refer to the specific service manual for the model year and configuration for precise values and procedures. Always use a torque wrench to ensure accurate measurements.
What else can I help you with?
What is the radiator capacity of a ej20 subaru engine?
7.6 L
What are the torque specifications for a Subaru Outback 2.0 TD engine?
You need to specify which torque settings. As with any vehicle, torque settings are specific to a particular part of the vehicle.The torque settings for the cylinder head will differ from the settings for the crankshaft bearings.
Torque specifications bolts suzuki esteem?
torque specifications
How do you replace a starter on 1994 Subaru legacy?
on an ej20 and ej22 subaru engines the starter is located at the top of the engine and is held by a bolt at the top and a nut at the bottom once you have removed these the starter will slide out back towards the firewall
How do you change timing belt for subaru ej20 4 cam?
Neither is a chain, it is simple sprocket linked to the main shaft, will last longer that the car itself
What are the torque specifications for a 2002 Saturn Sl2?
There are dozens of torque specifications, for the 2002 Saturn. A complete list of torque specifications, can be obtained from most General Motors dealerships
What is the lug nut torque for 2000 Subaru Outback?
The lug nut torque for your 2000 Subaru Outback is 58-72 ftlb according to the Subaru Owner's Manual.
What is the lug nut torque for 2007 Subaru Forrester?
The recommended lug nut torque for a 2007 Subaru Forester is typically 90 ft-lbs (foot-pounds). It's important to use a torque wrench to ensure proper tightening, as over-tightening can damage the wheel or hub assembly. Always refer to the vehicle's owner's manual for the most accurate specifications and guidelines.
What is the front strut torque spec for a 2010 Subaru Legacy?
The front strut torque specifications for a 2010 Subaru Legacy typically require that the upper strut mount nuts be torqued to about 14 ft-lbs (19 Nm) and the lower strut bolts to around 80 ft-lbs (108 Nm). It's crucial to consult the vehicle's service manual for precise specifications and any additional details specific to your model. Always use a calibrated torque wrench for accurate measurements.
How do you change thermostat on a ej20 Subaru?
To change the thermostat on a Subaru EJ20 engine, first, ensure the engine is cool and disconnect the negative battery terminal. Drain the coolant from the radiator and remove the upper radiator hose from the thermostat housing. Unbolt the thermostat housing, replace the old thermostat with a new one (ensuring the gasket is in place), and reassemble the housing and hoses. Finally, refill the coolant, start the engine, and check for leaks.
Torque specs for a 1995 Subaru impreza 2.2 head bolts?
Torque specs for a 1995 subaru impreza 2.2 head bolts?
What are the torque specifications for 1989 Mazda Truck 2200?
The specifications are 118 ft of torque per square inch. It also has This is at 2500 rpm's these are exact specifications.
