0
What else can I help you with?
What is the rod length of a reg 350 Chevy?
5.7"
What length push rod i need for my 305 Chevy?
The length of the push rod you need for a 305 Chevy typically ranges from 7.800 to 8.000 inches, depending on the specific application and whether you are using stock or aftermarket components. It's essential to measure the correct length by checking the valve train geometry and ensuring proper clearance. For the most accurate fit, consider using adjustable push rods during the setup or consult a professional for help.
What is the rod length of a 292 Chevy?
6.760"
What length push rod are needed to install 305 heads on stock 350 Chevy?
To install 305 heads on a stock 350 Chevy engine, you typically need push rods that are approximately 7.8 inches long. However, it's essential to verify the specific geometry of your engine setup, as variations in components can affect the required push rod length. Always check with a mechanic or engine builder to ensure proper fitment and performance.
What are the crank rod torque specs for a 1998 Chevy 305?
It depends on the brand of the rod bolts, but usually 45-50 ft/lbs.
What is the torque specification on the conecting rod cap nuts on a Chevy 305?
45 Lb/ft Below is a link to all small block Chevy torque specs.
What size push rod do you use with your Chevy 305 with a 350 camshaft?
For a Chevy 305 engine equipped with a 350 camshaft, you typically use push rods that are 5/16 inch in diameter and approximately 7.8 inches in length. However, it's important to verify the specific length needed based on your engine's setup, including the use of aftermarket components and the intended valve geometry. Always check for proper clearance and adjust lengths if necessary to ensure optimal performance.
What are the oil clearance specs for mains and rod bearing on a 305 Chevy?
Need more info, Like the year and what it is in.
What is rod length of 409 Chevy?
The rod length for a 409 Chevy engine is typically 6.135 inches. This measurement refers to the length of the connecting rods that link the pistons to the crankshaft. It's important to note that while this is the standard length, variations may exist depending on specific builds or modifications. Always consult the manufacturer's specifications or service manuals for precise information.
What does a blown rod sound like on a 305 Chevy?
Tick tick tick tick kaboom, bad sound, mine finally went to the oil pan when passing a cop
What would make a 305 out of a 1979 Chevy Monte Carlo stop running and not fire or crank?
rod bearings, pistons locked...thrown rod...could be a million things...best bet is to take it out and check the crankshaft and rods make sure nothing broke
Difference between big block Chevy truck rod and passenger car rod?
the big Chevy truck rod is bigger than a passenger car rod.
