The serpentine belt is a long belt on the front of the engine. The belt goes over a number of pulleys and powers many things such as the alternator and Power Steering all at once. The twisting and turning through all of the pulleys like a snake is how it came to be called a serpentine belt.
Loosen the tensioner pulley. The serpentine belt will become loose and can be removed. Put the new serpentine belt on and tighten the tensioner pulley.
Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.
you don't repair the serpentine belt. You buy a new one, they cost about 30 bucks
Popping
I have a '92 PA Ultra. The Ultra has the supercharger. There are two sets of serpentine belts for this configuration.
i need a 1992 mecerde-benz 300e 2.6 serpentine belt diagram
See "Related Questions" below for a few sources of serpentine routing diagrams.
probably damaged the crank sensor, or the tangs on the harmonic balancer
the serpentine belt may be slipping then grabbing as the tranny shifts gears.
Unhook the negative battery cable for safety. The belt tensioner needs to be rotated to release belt tension. Remove the old belt. Install the new belt in the same pulley directions that the old one went over. Release the tensioner. Reconnect the battery.
sounds like your pully tensioner might be bad, throwing the belt... which runs your alternator, which might be why the car wont start.
My 92 has the water pump on the passenger side, where serpentine belt is at but at the forward top of the engine. T HEMPLE it's on the right side of the motor where the sepentine belt is it is located at the bottom of the engine