answersLogoWhite

0

What else can I help you with?

Related Questions

How do you stop a squeaking belt on a car?

The belt needs to be properly tensioned and aligned. It may need to be loosened or tightened, or lined up with the pulley. Worn belts should be replaced. Occasionally belts may squeal or squeak even if properly installed. Although it is not recommended where other problems exist, there are retail sprays that can lubricate belts safely in these circumstances.


Why does 2005 Toyota sienna squeal when initially turning ac on?

The AC belts are probably stretched and loose. I had the same problem and replaced belts and cured squeak.


How do you set timing for 2002 Mazda 626?

I had a shop change my belts and plugs and now it runs really bad. I think that when they replaced the belts that they moved it out of time.


How many belts are on Mazda 626?

how many belts are in mazda 626


You replaced the heads on your 84 vanagon now one head makes a squeal noise when accelerating or de-accelerating anyone have any idea?

check and adjust belts


How much does it cost to replace the fan belt in a Mazda Protege?

I just replaced my fan belts on a 2002 Mazda Protege. It came out to a little over $200. I took my car to a Mazda dealership.


Automatic transmission fluid squeeling very loud?

Automatic transmission fluid does not squeal. You have a different problem. Brakes squeal, bearings squeal, and belts squeal. Fluids do not squeal. You had better take your vehicle to a mechanic.


Why would a 99 sephia squeal after changing belts water pump and powersteering pump?

After I had my belts replaced my a/c belt squealed the next day. But I returned to have it adjusted (mechanic said it probably would need it) and it's been fine since. Belts loosen up just a bit when new, I was told.


Why does Chrysler sebring squeal but only for a few minutes then stops?

Loose belts


Why does a Geo Storm squeal when accelerating?

Timing Belt.... Check all your belts.


What would cause your engine to squeal after it has gotten to operating temperature?

If the squealing noise is coming from the drive belts, perhaps they need to be replaced or one of the accessories has bad bearings and is seizing up when it gets hot.


What would cause your Mazda Protege5 to squeak while the heat is on at low speeds and when heat is off everything is fine. What would cause this?

Hello, I have a 2002 Protege5 with the same problem. I am quite sure that it is the serpentine belt as the squeal started after I had both belts replaced at 60,000 miles. I would check to see if one of them is too loose. Good Luck!